1994 Rover 416

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Nearside Front Mechanical brake component has restricted free movement (3.5.1k)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Rear Body has a sharp edge caused by corrosion outer sill (6.1.C.1)

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Mechanical brake component has restricted free movement (3.5.1k)

Offside Front Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a) DANGEROUS

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Stop lamp not working (1.2.1b)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Front registration plate character(s) likely to be misread (6.3.4b)

Nearside Front Front constant velocity joint gaiter insecurely mounted to its housing (2.5.C.1a)

Offside Front Anti-roll bar linkage rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Radius arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)