1994 Fiat Fiorino

Corrosion around the vehicle

Exhaust mounts tied on with wire

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Emissions not tested (8.2.1.2 (d))

Nearside Front Brake hose excessively damaged (1.1.12 (b) (ii))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Corrosion around the vehicle

Exhaust mounts tied on with wire

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust emissions carbon monoxide content excessive (8.2.1.2 (b))

Exhaust emissions hydrocarbon content excessive (8.2.1.2 (b))

Nearside Front Brake hose excessively deteriorated (1.1.12 (b) (ii))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Inner Suspension component mounting prescribed area is inadequately repaired sill (5.3.6 (a) (i))

Offside Rear Outer Suspension component mounting prescribed area is inadequately repaired sill (5.3.6 (a) (i))

Brake load sensing valve stiff (1.1.17 (c) (ii))

Front Anti-roll bar pin or bush worn but not resulting in excessive movement both (5.3.4 (a) (i))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

exhaust mounts missing and tied up with wire

general corrosion to vehicle

Central Exhaust mounting defective (6.1.2 (a))

Corrosion to various areas under vehicle

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Nearside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside & nearside C V gaiters deteriorated

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Offside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Central Exhaust mounting defective (6.1.2 (a))

Corrosion to various areas under vehicle

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Nearside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Offside & nearside C V gaiters deteriorated

Offside Front Anti-roll bar pin or bush worn but not resulting in excessive movement D bush (5.3.4 (a) (i))

Offside Front Brake hose slightly deteriorated (1.1.12 (b) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

General corrosion to underside and inner sills

Nearside Front Outer Constant velocity gaiter deteriorating

Rear Suspension arm has slight play in a pin/bush Both arms, all bushes (2.4.G.2)

Body has a sharp edge caused by corrosion Bonnet (6.1.C.1)

Exhaust has a major leak of exhaust gases Both boxes (7.1.2)

Front Brakes imbalanced across an axle 42% (3.7.B.5b)

Nearside Front Body has a projection caused by corrosion wing holed at mounting bolt (6.1.C.1)

Offside Body has a sharp edge caused by corrosion Door (6.1.C.1)

Steering system excessively rough (2.2.D.1)

Front Anti-roll bar has slight play in a pin/bush (2.4.G.2)

General corrosion to underside and inner sills

Nearside Front Outer Constant velocity gaiter deteriorating

Rear Suspension arm has slight play in a pin/bush Both arms, all bushes (2.4.G.2)

advise major weld repairs and genral corrosion throught underside of vehicle

front brake pipes showing corrosion

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

Exhaust emissions hydrocarbon content excessive (7.3.B.1b)

Nearside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings floor pan (6.1.B.2)

Nearside Lower Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings outer sill (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings floor pan (6.1.B.2)

Rear Brake load sensing valve defective and function impaired (3.6.E.3)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Front Brake pipe slightly corroded (3.6.B.2c)

cooling fan not operating

Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Anti-roll bar missing CLAMP (2.4.G.1)

Offside Rear Braking system leaking BRAKE PIPE (3.6.A.1)

Rear Brake pipe excessively corroded (3.6.B.2c)

Front Brake hose slightly deteriorated (3.6.B.4d)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Front Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Outer Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Front Anti-roll bar attachment bracket/mounting fractured (2.4.G.1)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Outer Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Centre Exhaust system not adequately supported (7.1.1)

Nearside Steering rack gaiter split (2.2.D.2d)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Steering system has slight free play detected at steering wheel (2.2.A.1b)

Front brake disc slightly pitted (3.5.1h)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Steering rack gaiter split (2.2.D.2d)

Front brake disc slightly pitted (3.5.1h)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

near side rear tyre side wall and tread cracked

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Exhaust emissions carbon monoxide content excessive (7.3.B.1a)

near side rear tyre side wall and tread cracked

near side rear tyre side wall split

wipers poor