1993 Rover Mini

Front Exhaust has a minor leak of exhaust gases pipe (6.1.2 (a))

no rear seat fitted at time of re-test (roll cage fitted to rear)

Battery insecure and likely to fall from carrier (4.13 (a) (ii))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Fuel cap/sealing device missing (6.1.3 (b) (i))

Nearside Front Side repeater missing (4.4.1 (a) (ii))

Nearside Front Vehicle structure corroded to the extent that the rigidity of the assembly is significantly reduced wheel arch (6.1.1 (c) (i))

Offside Side repeater missing (4.4.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Seat belt missing both rear seat belts missing (7.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Front Exhaust has a minor leak of exhaust gases pipe (6.1.2 (a))

Integral body structure is corroded but structural rigidity is not significantly reduced underside (6.1.1 (c) (i))

Nearside Front Integral body structure is corroded but structural rigidity is not significantly reduced sill (6.1.1 (c) (i))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Rear Rear seats not in at time of test

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Offside Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Emissions not tested Engine stalls and wont idle (8.2.1.2 (d))

Nearside Front Direction indicator not working (4.4.1 (a) (ii))

Nearside Rear Direction indicator not working (4.4.1 (a) (ii))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Position lamp not working All side lights not working (4.2.1 (a) (ii))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Driver's seat insecure (6.2.5 (a) (ii)) DANGEROUS

Offside Front Driver's seat insecure (6.2.5 (a) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Tyre slightly damaged/cracking or perishing Both rear (5.2.3 (d) (ii))

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Offside Obligatory mirror missing (8.1.1)

Rear Statutory seat belt missing (5.1.1)

Battery insecure (1.9.1)

Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Body or chassis is cracked, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Brake master cylinder/servo mounting prescribed area is excessively corroded (3.6.C.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear reflector missing (1.5.1a)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Road wheel with a slightly distorted bead rim (4.2.A.1a)

Offside Vehicle structure has slight corrosion (6.1.A.1)

Oil leak

Steering column top bearing slightly worn (2.1.2c)

Brake fluid warning lamp illuminated (3.6.G.2)

Brakes imbalanced across an axle (3.7.B.5b)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Passenger's seat cannot be secured in the upright position. (6.2.A.2)

Nearside Front Lower Suspension arm ball joint dust cover excessively damaged so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Steering rack gaiter split (2.2.D.2d)

Nearside Steering system has excessive free play detected at the steering wheel (steering rack fitted) (2.2.A.1b)

Offside Rear Brake pipe leaking (3.6.A.1)

Offside Steering rack gaiter split (2.2.D.2d)

Offside Steering system has excessive free play detected at the steering wheel (steering rack fitted) (2.2.A.1b)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Rear fog lamp not working (1.3.2b)

Nearside Side repeater not working (1.4.A.2c)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Windscreen wiper not operating automatically when switched on (8.2.1b)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Windscreen wiper not operating automatically when switched on (8.2.1b)

Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Offside Front Sub-frame attachment rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)