1996 Rover Mini

welding repairs satisfactory

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

welding repairs satisfactory

Brake pipe excessively corroded front to rear (1.1.11 (c))

Driver's seat fore and aft adjustment mechanism not functioning as intended. (6.2.5 (b) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust hydrocarbon content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Front Exhaust emissions likely to be affected by an exhaust leak downpipe (8.2.1.1 (b))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced behind shock absorber mount (6.1.1 (c) (i))

Offside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced boot floor (6.1.1 (c) (i))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Windscreen washer not working (3.5 (a))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced inner arch (6.1.1 (c) (i))

Offside Rear Integral body structure is corroded but structural rigidity is not significantly reduced inner arch (6.1.1 (c) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear Shock absorbers has a reduced damping effect both (5.3.2 (d))

existing welding repairs satisfactory

Front Exhaust silencer slightly loose lower down pipe corroded and cracked (8.1.1 (b) (i))

Nearside Front Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt split (2.1.3 (g) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated clip broken (6.1.7 (g) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Rear Service brake effort inadequate at a wheel (1.2.1 (a) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Windscreen washer not working (3.5 (a))

Front Exhaust silencer slightly loose lower down pipe corroded and cracked (8.1.1 (b) (i))

Nearside Front Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt split (2.1.3 (g) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated clip broken (6.1.7 (g) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Exhaust catalytic converter missing where one was fitted as standard (8.2.1.1 (a))

Exhaust emissions carbon monoxide content excessive 700 (8.2.1.2 (b))

Exhaust emissions hydrocarbon content excessive 8110 (8.2.1.2 (b))

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (8.1.1 (a))

Front Registration plate incorrect (0.1 (c))

Offside Front Headlamp has a product on the light source so that the light output is severely reduced (4.1.4 (b))

Offside Rear Rear fog lamp not working (4.5.1 (a) (ii))

Rear Registration plate incorrect (0.1 (c))

Nearside Front Headlamp reflector slightly defective (4.1.1 (b) (i))

Offside Rear Rear fog lamp not working (1.3.2b)

Offside Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust catalytic converter missing where one was fitted as standard middle (7.1.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Front position lamp(s) not working (1.1.A.3b)

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Rear fog lamp missing (1.3.2a)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Rear Brakes imbalanced across an axle Axle 2 (3.7.B.5b)

Offside Front Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Offside Front Brake hose leaking (3.6.A.1)

Offside Front Wheel bolt(s) missing (4.2.A.1e)

Windscreen washer provides insufficient washer liquid (8.2.3)

nearside and offside rear floor pans have surface corrossion

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Wheel stud(s) missing (4.2.A.1e)

Nearside Rear Seat belt locking mechanism does not secure or release (5.2.5a)

Nearside Upper Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Front Side repeater missing (1.4.A.2b)

Offside Front Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Parking brake: efficiency below requirements (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Upper Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Nearside Rear Exhaust system not adequately supported (7.1.1)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Exhaust system not adequately supported (7.1.1)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Front wheel bearing has slight play (2.5.A.3c)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Sub-frame attachment bracket/mounting nut missing (2.4.G.1)

Offside Front Sub-frame attachment bracket/mounting nut missing (2.4.G.1)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Offside Rear rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Front wheel bearing has slight play (2.5.A.3c)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Front registration plate character(s) incorrectly spaced (6.3.4a)

Rear registration plate character(s) incorrectly spaced (6.3.4a)

Front registration plate deteriorated (6.3.1d)

Rear registration plate faded (6.3.1d)