1993 Fiat Panda

Brake lever has insufficient reserve travel (1.1.2 (a))

Horn not working (7.7 (a))

Main beam tell-tale not working (4.9.1 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Nearside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced Outer sill (7.1.1 (a) (i))

Offside Front Brake pipe excessively corroded From the flexible hose (1.1.11 (c))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Rear Shock absorbers has an excessively worn bush (5.3.2 (c))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Chassis (5.3.6 (a) (i))

Parking (secondary brake) on a single line braking system imbalanced across an axle Axle 1 (1.3.1 (b) (i))

Rear fog lamp tell-tale not working (4.9.1 (a) (ii))

Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Oil leaking continuously from transmission posing a serious risk to road safety (8.4.1 (a) (ii)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Coil spring corroded Both fronts (5.3.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge Tyre worn below 2mm the legal limit being 1.6mm Also worn on the inner edge (5.2.3 (e))

Nearside Play in steering rack inner joint(s) ()

Nearside Rear Coil Spring incorrectly seated

Nearside Rear Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Brake pipe inadequately clipped or supported (1.1.11 (d) (i))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Tyre worn close to legal limit/worn on edge Worn below 2mm in places (5.2.3 (e))

Rear Exhaust mounting defective (6.1.2 (a))

Suspension arm corroded but not seriously weakened Both rears (5.3.3 (b) (i))

Topped up engine oil prior to the test

Central Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Suspension component mounting repair covered in underseal sills to floor (5.3.6 (a) (i))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Nearside Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Seat belt anchorage prescribed area strength or continuity significantly reduced offside and nearside inner sills (7.1.1 (a) (i))

Windscreen washer not working (3.5 (a))

inner and outer sills corroded

Offside Front Tyre worn close to the legal limit (4.1.E.1)

sills to floor and nearside front floor corroded

Offside Rear fog lamp not working (1.3.2b)

Suspension component mounting prescribed area is excessively corroded offside and nearside rear inner and outer sills (2.4.A.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

sills to floor and nearside front floor corroded

Nearside Rear Brake pipe slightly corroded (3.6.B.2c)

Offside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

floor to sill area corroded but not considered excessive nearside and offside