1993 Yamaha SR125

Offside Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Drive chain horseshoe locking device incorrectly fitted (6.1.7 (j) (i))

Front Steering headbearing has excessive wear or free play excessive play in top bearing with weight on front wheel (2.2.2 (f) (i))

Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Front Headlamp aim projected beam image obviously incorrect (4.1.2 (c))

Rear Motorcycle structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Rear Brake component insecure (1.1.21 (c))

Rear Motorcycle structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

Drive chain worn but not considered excessive (6.2.1e)

Front Drive chain sprocket slightly worn (6.2.1e)

Nearside Front shock absorber has light misting of stanchion (2.3.3)

Rear Drive chain sprocket slightly worn (6.2.1e)

Exhaust is leaking and excessively noisey (7.1.1b)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Locking devices not correctly fitted which may make the motor bicycle dangerous to ride (6.2.1h)

Exhaust is leaking and excessively noisey (7.1.1b)

Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.2a(i))

Rear Tyre worn close to the legal limit (4.1.3(ii))

Rear Tyre worn close to the legal limit (4.1.3(ii))

Exhaust is leaking and excessively noisey (7.1.1b)

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Front shock absorber seal failed and leaking oil (2.3.3)

Rear Motorcycle structure excessively corroded (6.1.1a)

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Rear Tyre worn close to the legal limit (4.1.3(ii))

Direction indicators flashing less than 60 times a minute (1.5.1c)

Lower Motorcycle structure slightly corroded (6.1.1a)

Lower Motorcycle structure slightly corroded (6.1.1a)

Rear wheel spindle securing nut(s) loose (2.4.A.2b)