1993 Rover Mini

Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security hole under floor under sealed including brake pipes (6.2.2 (d) (i))

both front wings coroded and gaffer taped smart repair

both rear quaters coroded bottom

front vallance slitghtly coroded

body has general corrosion

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Suspension arm ball joint excessively worn lower (5.3.4 (a) (i))

Nearside Front Windscreen wiper not working (3.4 (a))

Nearside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner arch (x2) (5.3.6 (a) (i))

Offside Front Headlamp insecure (4.1.1 (c))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Windscreen wiper not working (3.4 (a))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Rear Subframe mounting prescribed area excessively corroded significantly reducing structural strength inner arch(x3) (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor (5.3.6 (a) (i))

Nearside Front Suspension arm ball joint has slight play upper (5.3.4 (a) (i))

Offside Brake pipe corroded, covered in grease or other material front to rear (1.1.11 (c))

Offside Rear tyre badly out of shape and close to subframe

both front subframe mountings deteriorating

slight corrosion in places

water leak inside of vehicle(heater matrix)

o/s/f wheel arch trim missing

Offside Front Sub-frame attachment rubber mounting bonding deteriorated resulting in excessive movement front subframe (2.4.G.2)

o/s/f wheel arch trim missing

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Upper Suspension component mounting prescribed area is excessively corroded shock absorber mounting (2.4.A.3)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

oil leak noted.

Centre Brake pipe inadequately supported front to rear. (3.6.B.1)

Nearside Headlamp aim too low (1.8)

Nearside Track rod end loose (2.2.B.1d)

Offside Headlamp aim too low (1.8)

oil leak noted.

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Steering rack gaiter deteriorated (2.2.D.2d)

Nearside front tyre perished/cracked

Offside Front Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside front tyre perished/cracked

Offside rear tyre perished/cracked

Oil leak

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too high (1.8)

Nearside Rear Brake cable has wires broken and is significantly weakened (3.5.1b)

Nearside Stop lamp not working (1.2.1b)

Offside Front Upper Brake master cylinder/servo mounting prescribed area is excessively corroded (3.6.C.3)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Headlamp aim too high (1.8)

Offside Rear Seat belt damaged sufficient to significantly weakened the webbing (5.2.2a)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Upper Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Steering rack gaiter split (2.2.D.2d)

Offside Stop lamp not working (1.2.1b)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Steering rack gaiter deteriorated (2.2.D.2d)

Nearside front tyre perished/cracked

Offside Front Lower Suspension arm has slight play in a ball joint (2.4.G.2)

Offside Front Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front wheel bearing has slight play (2.5.A.3c)

Offside Rear Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside front tyre perished/cracked

Offside rear tyre perished/cracked

Oil leak

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Offside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Offside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Parking brake lever has little reserve travel (3.1.6b)

Nearside Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

idle speed slightly high

front bump stop clearance could be better

Brake pad(s) wearing thin (3.5.1g)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

exhaust heat shield insecure

Nearside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Nearside Rear Radius arm locating pin insecure (2.4.G.3a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Steering rack gaiter split (2.2.D.2d)

Offside Front suspension has excessive play in a upper suspension ball joint (2.5.B.1a)

Offside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside Steering rack gaiter split (2.2.D.2d)

Brake pad(s) wearing thin (3.5.1g)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

exhaust heat shield insecure

front bump stop clearance could be better

idle speed slightly high

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Shock absorber has a slightly reduced damping effect (2.7.5)

front brake pads lowish

wipers could clear better

Nearside Front constant velocity joint gaiter split (2.5.C.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Front constant velocity joint gaiter split (2.5.C.1a)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Offside Rear Radius arm locating pin insecure (2.4.G.3a)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Registration plate lamp not working (1.1.C.1d)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Vehicle structure has slight corrosion (6.1.A.1)

Offside Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Offside Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

cooling fan broken

front suspension bump stop claerance could better

Nearside Rear Radius arm has excessive play in a pin/bush (2.4.G.2)

Offside Front Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Sub-frame corroded and seriously weakened (2.4.G.1)

Service brake: efficiency below requirements (3.7.B.7)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Offside Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

front number plate cracked

Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Nearside Rear Radius arm has excessive play in a pin/bush (2.4.G.2)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Service brake: efficiency below requirements (3.7.B.7)

Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

Nearside Front Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Offside Front Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Shock absorber has a slightly reduced damping effect (2.7.5)

Nearside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

corrosion outside of 30 cm o/s/f sub frame mounting

corrosion starting on rear sub frame mountings

Nearside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Front Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Nearside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Front Front suspension has slight play in a lower suspension ball joint (2.5.B.1a)

corrosion outside of 30 cm o/s/f sub frame mounting

corrosion starting on rear sub frame mountings

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside rear brake recording little or no effort (3.7.B.5a)