1994 Rover Mini

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Driver's seat insecure (6.2.A.1)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front Sub-frame attachment rubber mounting bonding deteriorated resulting in excessive movement (2.4.G.2)

Front Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Radius arm has excessive play in a pin/bearing (2.4.G.2)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Steering rack gaiter split (2.2.D.2d)

Nearside Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside Rear Radius arm has excessive play in a pin/bearing (2.4.G.2)

Offside Steering rack gaiter split (2.2.D.2d)

Offside Suspension has inadequate clearance with the bump stop (2.4.A.1a)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Steering column top bearing excessively worn (2.1.2c)

rear brake application uneven (3.7.B.2)

Parking brake: efficiency below requirements (3.7.B.7) DANGEROUS

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Front Upper Exhaust system not adequately supported (7.1.1)

Nearside Front Direction indicator incorrect colour (1.4.A.2f)

Nearside Front Headlamp aim too high (1.8)

Nearside Front Upper Passenger's seat insecure (6.2.A.1)

Nearside Front Upper Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Nearside Inner Front Lower Sub-frame attachment rubber mounting bonding deteriorated resulting in excessive movement (2.4.G.2)

Nearside Inner Front Lower Subframe mounting prescribed area is fractured (2.4.A.3)

Nearside Inner Front Steering rack gaiter split (2.2.D.2d)

Nearside Outer Front Lower Sub-frame attachment rubber mounting bonding deteriorated resulting in excessive movement (2.4.G.2)

Nearside Rear Lower Radius arm has excessive play in a pin/bearing (2.4.G.2)

Offside Front Direction indicator incorrect colour (1.4.A.2f)

Offside Front Headlamp aim too high (1.8)

Offside Front Lower Driver's seat insecure (6.2.A.1)

Offside Front Upper Sub-frame attachment rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Inner Front Front constant velocity joint is insecure (2.5.C.1b)

Offside Inner Front Lower Seat belt insecurely fixed to the vehicles structure (5.2.1a)

Offside Inner Front Steering rack gaiter split (2.2.D.2d)

Offside Inner Front Upper Seat belt anchorage prescribed area is excessively corroded (5.2.6)

Offside Rear Lower Radius arm has excessive play in a pin/bearing (2.4.G.2)

Offside rear brake recording little or no effort (3.7.B.5a)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Headlamp deteriorated but light output not reduced (1.7.5a)

Nearside Front Steering column top bearing slightly worn (2.1.2c)

Oil leak

Rear Lower Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

front suspension swivels joints / arms grease points dry

lower steering column bush worn/ slight free movement

near side front door slightly difficult to open / release from in side lever

near side rear tyre inner treads edge worn

off side front tyre inner treads edge worn

Exhaust noisy (7.1.4)

Nearside Front Body has slight corrosion (6.1.B.2)

Nearside Front Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Offside Front Body has slight corrosion (6.1.B.2)

Offside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Offside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Offside front brake juddering slightly (3.7.A.2b)

Steering column top bearing slightly worn (2.1.2c)

both front wipers slightly smeary

Offside Rear fog lamp not working (1.3.2b)

Rear fog lamp tell tale not working (1.3.1b)

Exhaust noisy (7.1.4)

Nearside Front Body has slight corrosion (6.1.B.2)

Nearside Front Sub-frame rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Offside Front Body has slight corrosion (6.1.B.2)

Offside Front suspension has slight play in a upper suspension ball joint (2.5.B.1a)

Offside Rear Radius arm has slight play in a pin/bush (2.4.G.2)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside front brake juddering slightly (3.7.A.2b)

Steering column top bearing slightly worn (2.1.2c)

both front wipers slightly smeary

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Nearside Front Upper Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear fog lamp not working (1.3.2b)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Driver's seat cannot be secured in the upright position. (6.2.A.2)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Front Windscreen washer provides insufficient washer liquid (8.2.3)

Headlamp aim too high (1.8)

Nearside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Suspension arm has excessive play in a pin/bearing (2.4.G.2)

Offside Rear Subframe mounting prescribed area is excessively corroded (2.4.A.3)

Service brake: efficiency below requirements (3.7.B.7)

Brake master cylinder insecurely mounted (3.6.G.1a)

Nearside rear brake recording little or no effort (3.7.B.5a)

Radius arm has slight play in a pin/bush (2.4.G.2)

Rear Sub-frame corroded but not seriously weakened (2.4.G.1)

Seat belt anchorage prescribed area is corroded but not considered excessive (5.2.6)

Subframe mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)