1994 Mazda MX-5

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Nearside Front Bumper insecure nose cone insecure (6.1.4 (a) (i))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor to sill...marked (5.3.6 (a) (i))

Offside Front Service brake excessively binding (1.2.1 (f))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor to sill...marked (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength chassis leg..marked (5.3.6 (a) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front backplate insecure

front and rear subframes and suspension units corroded

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Exhaust emissions likely to be affected by an exhaust leak emissions not tested (8.2.1.1 (b))

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust has a major leak of exhaust gases (7.1.2)

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill/arch (6.1.B.2)

Offside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings sill/arch (6.1.B.2)

Offside Front Brake pipe excessively corroded burst (3.6.B.2c) DANGEROUS

Nearside Front Wheel nut(s) loose (4.2.A.1e)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

surface corrosion at outersills

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust system not adequately supported (7.1.1)

Nearside Front Shock absorber has an excessively worn bush (2.7.4)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside rear brake binding (3.7.B.1)

Parking brake: efficiency below requirements (3.7.B.7)

Stop lamp not working (1.2.1b)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

exhaust fowling on rear axle

surface corrosion at outersills

Chips on screen

Condition of rear brake discs

Corosion throughout undebrody

Exhaust has a minor leak of exhaust gases (7.1.2)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Wear to all 4 tyres on edges

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Rear Stop lamp not working (1.2.1b)

Nearside front brake grabbing severely (3.7.A.2b)

Nearside rear brake binding (3.7.B.1)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Service brake: efficiency below requirements (3.7.B.7)

front brake application uneven (3.7.B.2)

rear brake application uneven (3.7.B.2)

Chips on screen

Condition of rear brake discs

Corosion throughout undebrody

Exhaust has part of the system slightly deteriorated (7.1.1a)

Wear to all 4 tyres on edges

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Brake pad(s) wearing thin (3.5.1g)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)