1994 Saab 9000 Cse

Nearside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front coil spring corroded (2.4.C.1b)

Offside Front Lower Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Front coil spring corroded (2.4.C.1b)

Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Registration plate lamp not working (1.1.5c)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Anti-roll bar has slight play in a pin/bush (2.4.G.2)

smaller wiper blades fitted at time of test

Centre Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

offside rear brake flexi retaining clip missing

oil leak around engine & gearbox area

smaller wiper blades fitted to vehicle

Nearside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear Brake pipe inadequately clipped (3.6.B.1)

Parking brake lever has no reserve travel (3.1.6b)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

Centre Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

offside rear brake flexi retainig clip missing

oil leak around engine & gearbox area

Emissions not tested (7.0)

Nearside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Front Lower Suspension arm has excessive play in a ball joint (2.4.G.2)

Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

ENGINE OVERHEATING cooling fan not functioning