2003 BMW M3

Electronic stability control warning lamp indicates a fault (7.12 (e))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Front Headlamp levelling device inoperative (4.1.5 (a))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Brake pipe corroded, covered in grease or other material main front to rear (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

engine light on

tyre pressure light on

Brake pedal has insufficient reserve travel (1.1.2 (a))

Emissions not tested engine misfire (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Headlamp levelling device inoperative (4.1.5 (a))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Brake pipe corroded, covered in grease or other material main (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Brake hose has slight corrosion to ferrule both (1.1.12 (f) (i))

tyre pressure light on

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Brake pipe slightly corroded main front to rear (3.6.B.2c)

Offside Front Brake pipe slightly corroded (3.6.B.2c)

Rear Brake pad(s) wearing thin (3.5.1g)

front discs corroded

front tyre side walls cracking

rear exhaust clamp cracked

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Electronic stability system warning lamp indicates a fault (3.4.1c)

Offside Rear Trailing arm rubber bush deteriorated resulting in excessive movement (2.4.G.2)

Offside Rear coil spring broken (2.4.C.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Engine covers fitted obscuring some components in the engine bay

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Under-trays fitted obscuring some underside components

Brake hydraulic reservoir fluid level below minimum level (3.6.G.1b)

Offside Brake pipe excessively corroded (3.6.B.2c)

Offside Brake pipe leaking (3.6.A.1)

Service brake: efficiency below requirements (3.7.B.7)

Engine covers fitted obscuring some components in the engine bay

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Under-trays fitted obscuring some underside components

both front tyres wearing on outer edge

nearside front brake binding slightly

Rear coil spring incomplete (2.4.C.1a)

front tyres wearing inner/outter edges