1993 Mercedes-benz 308 D

Horn not working (7.7 (a))

Nearside Front Headlamp aim too high (4.1.2 (a))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Offside Rear Service brake imbalanced across an axle Low Effectiveness (1.2.1 (b) (i))

Rear Brakes imbalanced across an axle Axle 2 (1.2.1 (b) (i))

Rear Rear reflector missing Both Sides (4.8.2 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Central Exhaust has a minor leak of exhaust gases Mid Box, Front Join (6.1.2 (a))

Nearside Front Axle swivel pins and bushes swivel pin and/or bush slightly worn Slight Play (5.1.2 (b) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Rear Unable to test wheel bearing

Offside Front Outer Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Brake hose slightly deteriorated (1.1.12 (b) (ii))

Front Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Rear Vehicle structure has slight corrosion (6.1.A.1)

Offside Front Vehicle structure has slight corrosion (6.1.A.1)

Nearside Front brake disc in such a condition that it is seriously weakened and o/s/f (3.5.1i)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings and o/s/r leaf spring mount (6.1.B.2)

Nearside Rear Body or chassis has excessive corrosion, seriously affecting its strength within 30cm of the body mountings and o/s/r sills as marked (6.1.B.2)

Nearside Rear Rear position lamp(s) not working and o/s/r (1.1.A.3b)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Rear Brake valve locking device missing ant roll bar link demage (3.6.A.2d)

Front Vehicle structure has slight corrosion (6.1.B.2)

Nearside Front Vehicle structure has slight corrosion (6.1.B.2)

Offside Front Vehicle structure has slight corrosion (6.1.B.2)

Offside Vehicle structure has slight corrosion (6.1.B.2)

Temporary fuel cap fitted

Front registration plate character(s) laid out in an incorrect format (6.3.4f)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Rear Exhaust system not adequately supported (7.1.1) DANGEROUS

Front Vehicle structure has slight corrosion (6.1.B.2)

Nearside Front Vehicle structure has slight corrosion (6.1.B.2)

Offside Front Vehicle structure has slight corrosion (6.1.B.2)

Offside Vehicle structure has slight corrosion (6.1.B.2)

Temporary fuel cap fitted

Front registration plate character(s) not correctly formed (6.3.4b)

Nearside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Nearside Rear position lamp(s) not working (1.1.A.3b)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Front Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Offside Rear Vehicle structure has excessive corrosion, seriously affecting its strength within 30cm of the body mountings (6.1.B.2)

Rear Exhaust has a major leak of exhaust gases (7.1.2)

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (4.1.D.1b) DANGEROUS

Rear Exhaust system not adequately supported (7.1.1) DANGEROUS

Front Vehicle structure has slight corrosion (6.1.B.2)

Nearside Front Vehicle structure has slight corrosion (6.1.B.2)

Offside Front Body has slight corrosion (6.1.B.2)

Offside Rear Body has slight corrosion (6.1.B.2)

Offside Rear Vehicle structure has slight corrosion (6.1.B.2)

Offside front tyre has small cuts on the tread

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Brake load sensing valve linkage stiff (3.6.E.3)

Exhaust has a minor leak of exhaust gases (7.1.2)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Inner Front Upper Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Oil leak

Rear Upper Suspension spring mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Steering system has slight free play detected at steering wheel (2.2.A.1a)

Temporary fuel cap fitted

body corroding and weak in lower areas.sharp edges forming

exhaust corroded and supports poor

underside and structure has corrosion and weak points on and or near prescribed areas

Brake load sensing valve stiff (3.6.E.3)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Exhaust System Rusty

Front registration plate deteriorated but not likely to be misread (6.3.1d)

General Corrosion On Underside And Outside Of Vehicle

Nearside Rear Brake Slightly Binding

Rear Exhaust Bracket Snapped

Slight Oil Leak

Slight Play In Steering System

near side rear brake binding

Nearside Indicator tell tale inoperative (1.4.A.2a)

Rear registration plate deteriorated (6.3.1d)

near side rear brake binding

Exhaust has part of the system slightly deteriorated (7.1.1a)

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both rear bumper end caps missing

free play at steering wheel

front and rear no plates delaminating

front metal brake pipes corroded

nearside front body work corroded and holed

underside of vehicle corroded

Fuel tank leaking (7.2.3)

Nearside Front Suspension component mounting prescribed area is excessively corroded (2.4.A.3)

Nearside Headlamp aim too low (1.8)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Offside Rear fog lamp not working (1.3.2b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Brake load sensing valve linkage seized (3.6.E.3)

Rear fog lamp tell tale not working (1.3.1b)

Service brake: efficiency below requirements (3.7.B.7)

Exhaust has part of the system slightly deteriorated (7.1.1a)

Oil leak

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

both rear bumper end caps missing

free play at steering wheel

front and rear no plates delaminating

front metal brake pipes corroded

nearside front body work corroded and holed

underside of vehicle corroded

Rear Exhaust mounting missing (7.1.1b)