1994 Mercedes-benz C

Front Suspension arm rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)

Offside Indicator tell tale inoperative (1.4.A.2a)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Non obligatory mirror damaged

Offside Front wheel bearing has slight play (2.5.A.3c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Exhaust system not adequately supported (7.1.1)

Offside Front coil spring fractured (2.4.C.1a)

Offside Front suspension has excessive play in a lower suspension ball joint (2.5.B.1a)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Non obligatory mirror damaged

Offside Front wheel bearing has slight play (2.5.A.3c)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Nearside Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Nearside Stop lamp not working (1.2.1b)

Nearside Tyre(s) incorrect because tyres with different aspect ratios are fitted on the same axle. (4.1.A.1a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

srs light on ,o/s/r outer sidelight dim ,n/s headlight beam dim & rear pads close to antirattle shims

Nearside Front Suspension arm has excessive play in a ball joint (2.4.G.2)

Offside Rear position lamp(s) excessively damaged so that it is not visible from a reasonable distance (1.1.A.3d)

Rear Tyre(s) incorrect because different size tyres are fitted on the same axle. (4.1.A.1a)

Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Suspension arm has slight play in a ball joint (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)