2010 Kia Picanto

Front Exhaust mounting defective (6.1.2 (a))

Nearside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Inner Tyre worn close to legal limit/worn on edge bold on edge and on 2mm (5.2.3 (e))

Nearside Front Nail in tyre ()

Nearside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Inner Tyre worn close to legal limit/worn on edge worn bold on edge and on 2mm (5.2.3 (e))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Direction indicator not working (4.4.1 (a) (ii))

Offside Headlamp aim too low and too far to the left. (4.1.2 (a))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Electrical wiring insecure abs wire (4.11 (a) (i))

Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Rear fog lamp not working (4.5.1 (a) (ii))

Rear fog lamp switch inoperative (4.5.3 (a))

Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Rear Coil spring fractured or broken (5.3.1 (b) (i))

Front Exhaust mounting defective (6.1.2 (a))

Exhaust front support bracket is broken.

Front registration plate delaminated but not likely to be misread (6.3.1d)

Front registration plate delaminated but not likely to be misread (6.3.1d)

Nearside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Macpherson strut has slight movement in the upper support bearing assembly both front (2.5.B.1b)

exahust front mounting bracket has corssion

Front registration plate deteriorated but not likely to be misread (6.3.1d)

tyre sealant out of date