2006 Seat Leon

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement front bush (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement front bush (5.3.4 (a) (i))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement front bush (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement front bush (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Brake disc worn, but not excessively front brake pads getting low (1.1.14 (a) (i))

Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

front brake pads getting low

offside front tyre wearing on edges

Nearside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Offside Front Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

front brake pads getting low

nearside handbrake performance lower than offside

rear number plate water marked

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Tyre has a lump, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

nearside handbrake performance lower than offside

rear number plate water marked

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Supplementary restraint system warning lamp indicates a fault (7.1.6 (a))

offside front tyre wearing on edges

Nearside Rear Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

offside front tyre wearing on edges

front and rear brake discs slightly worn

front and rear brake pads wearing low

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Suspension arm has excessive play in a pin/bush lower arm front bush (2.4.G.2)

Offside Front Suspension arm has excessive play in a pin/bush lower arm front bush (2.4.G.2)

nearside front tyre worn very close to legal limit

offside front lower arm rear bush perished and has slight play

offside front outer cv gaiter split around inner clip

offside front tyre worn very close to legal limit, just legal advise replacement

Nearside Headlamp aim too high (1.8)

Front Brake pad(s) wearing thin (3.5.1g)

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)