2012 Smart Fortwo Passion CDI Auto

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Headlamp aim too low and too far to the right. (4.1.2 (a))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Position lamp light intensity significantly reduced (4.2.3 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Offside Rear Service brake excessively binding (1.2.1 (f))

Both outer sill covers insecure

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Both outer sill covers insecure

Offside Windscreen wiper does not clear the windscreen effectively 21" FF (3.4 (b) (ii))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside sill cover insecure

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Side repeater not working (4.4.1 (a) (ii))

near side sill cover loose

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front Brake pad(s) wearing thin (3.5.1g)

front wearing on inside edges

Offside Headlamp not working on dipped beam (1.7.5a)

Front Brake pad(s) wearing thin (3.5.1g)

front wearing on inside edges

Engine bay covers and under trays fitted not allowing full inspection.

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)