2008 Honda Accord

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor pan corrosion (7.1.1 (a) (i))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced floor pan corrosion (7.1.1 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill end (5.3.6 (a) (i))

Nearside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Front Seat belt anchorage prescribed area strength or continuity significantly reduced floor pan corrosion (7.1.1 (a) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Rear Seat belt anchorage prescribed area strength or continuity significantly reduced floor pan corrosion (7.1.1 (a) (i))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Rear Inner Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Power steering component leaking (2.1.5 (a))

Front Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Front Bush. (5.3.4 (a) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement Front Bush. (5.3.4 (a) (i))

Plastic Sill Trims Fitted Not Allowing Full Inspection Of Outer Sill.

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement Both D Bushes. (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Both Inner Sill Areas. (5.3.6 (a) (i))

Tow Bar Slightly Corroded.

Towbar slightly corroded within 30cm of towbar mounting Both Sides. (6.1.6 (i) (i))

Nearside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Front Upper Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement Front Bush. (5.3.4 (a) (i))

Nearside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Headlamp lens slightly defective (4.1.1 (b) (i))

Offside Front Upper Suspension arm pin or bush worn but not resulting in excessive movement Front Bush. (5.3.4 (a) (i))

Plastic Sill Trims Fitted Not Allowing Full Inspection Of Outer Sill.

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement Both D Bushes. (5.3.4 (a) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive Both Inner Sill Areas. (5.3.6 (a) (i))

Tow Bar Slightly Corroded.

Towbar slightly corroded within 30cm of towbar mounting Both Sides. (6.1.6 (i) (i))

Both Rear Inner Sills Surface Corrosion

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement D Bush (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement D Bush (5.3.4 (a) (i))

Plastic Trims Fitted To Outer Sills

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Tow Bar Slightly Corroded

Towbar slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

Nearside Front Headlamp light intensity severely reduced (4.1.4 (a))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Headlamp light intensity severely reduced (4.1.4 (a))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Both Rear Inner Sills Surface Corrosion

Nearside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement D Bush (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Anti-roll bar pin or bush worn but not resulting in excessive movement D Bush (5.3.4 (a) (i))

Plastic Trims Fitted To Outer Sills

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Subframe mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Tow Bar Slightly Corroded

Towbar slightly corroded within 30cm of towbar mounting (6.1.6 (i) (i))

advise off side rear light lens broken

rear chassis corrosion both sides

Offside Headlamp aim aimed so that it dazzles other road users (1.8.A.1a)

Registration plate lamp not working (1.1.C.1d)

Stop lamp not working both outer stop lights (1.2.1b)

Windscreen wiper does not clear the windscreen effectively both (8.2.2)

advise off side rear light lens broken

rear chassis corrosion both sides

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Nearside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Rear Anti-roll bar rubber mounting deteriorated but not resulting in excessive movement (2.4.G.2)

Offside Registration plate lamp not working (1.1.C.1d)

Tyre worn close to the legal limit all four (4.1.E.1)

Nearside Front Suspension arm rubber bush bonding deteriorated resulting in excessive movement front bush (2.4.G.2)

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Tyre worn close to the legal limit all four (4.1.E.1)

Offside Rear position lamp(s) damaged, but still visible from a reasonable distance (1.1.A.3d)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Front Brake pad(s) wearing thin (3.5.1g)

Offside Rear position lamp(s) damaged, but still visible from a reasonable distance (1.1.A.3d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)