2008 Kia Sorento

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Fuel Pipe/s corroded ()

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm front bush (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm front bush (5.3.4 (a) (i))

Power steering component has slight seepage from a component rack (2.1.5 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember (5.3.6 (a) (i))

Offside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength crossmember (5.3.6 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Fuel Pipe/s corroded ()

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm front bush (5.3.4 (a) (i))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement trailing arm front bush (5.3.4 (a) (i))

Power steering component has slight seepage from a component rack (2.1.5 (a))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Brake pivot has restricted free movement parking brake cable pivot (1.1.15 (e))

Nearside Brake pipe excessively corroded front to rear (1.1.11 (c))

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Stop lamp(s) not working (4.3.1 (a) (ii))

Offside Brake pipe excessively corroded front to rear (1.1.11 (c))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Prop shaft joint excessively worn front shaft, centre joint (6.1.7 (c) (i))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Tyre slightly damaged/cracking or perishing both rears (5.2.3 (d) (ii))

Nearside Rear Upper Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Side repeater slightly discoloured (4.4.3 (a))

Offside Side repeater slightly discoloured (4.4.3 (a))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Fluid leak, but not excessive fuel tank (8.4.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Outer Brake pad(s) wearing thin (1.1.13 (a) (ii))

Brake lever has insufficient reserve travel (1.1.2 (a))

Service brake efficiency below requirements (1.2.2 (a) (i))

Fluid leak, but not excessive fuel tank (8.4.1 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Outer Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Lower Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Transfer box props haft worn

Battery insecure (1.9.1)

Nearside Front Upper Suspension arm has excessive play in a ball joint Top arm ball joint (2.4.G.2)

Transfer box props haft worn

Transfer box props haft worn

Nearside Front Tie bar/rod has excessive play in a ball joint (2.4.G.2)

Offside Rear Tie bar/rod has excessive play in a ball joint (2.4.G.2)

Rear Brake pad(s) wearing thin (3.5.1g)

Transfer box props haft worn

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front Brake pad(s) wearing thin (3.5.1g)

Windscreen has damage to an area less than a 10mm circle within zone 'A' (8.3.1a)