2010 Honda Civic

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Track rod end slightly misaligned (2.1.3 (e))

Offside Front Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Anti-roll bar linkage ball joint has slight play (5.3.4 (a) (i))

Nearside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Rear Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. calliper weak (1.4.2 (a) (i))

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement both sides, 'D' bushes (5.3.4 (a) (i))

Rear Service brake fluctuating, but not excessively both sides (1.2.1 (e))

Rear Tyre worn close to legal limit/worn on edge both sides, worn edges (5.2.3 (e))

parking brake lever has little reserve travel

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Service brake excessively fluctuating (1.2.1 (e))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Parking brake lever has little reserve travel (3.1.6b)

Rear Tyre worn close to the legal limit both sides, also worn on inner edges (4.1.E.1)

BOTH FRONT AND N/S/R TYRES SHOWING WEAR

FRONT BRAKE PADS GETTING LOW

VEHICLE IS OF HYBRID DESIGN AND SO NO EMISSION TEST REQUIRED

Nearside Front Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front position lamp(s) not working (1.1.A.3b)