2002 Lexus LS430

Emissions unable to be completed (8.2.1.2 (d))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust has a major leak of exhaust gases exhaust section missing (6.1.2 (a))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Headlamp levelling device inoperative (4.1.5 (a))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Steering rack gaiter missing or no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Windscreen washer not working (3.5 (a))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

engine covers and under trays obscure some testable areas/items

front under tray loose

general corrosion to underside and components

sill covers fitted

Emissions not tested exhaust blowing (8.2.1.2 (d))

Emissions not tested exhaust leak (8.2.1.2 (d))

Front Exhaust has a major leak of exhaust gases (6.1.2 (a))

Nearside Front Service brake excessively fluctuating (1.2.1 (e))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor at sill edge (5.3.6 (a) (i))

Offside Front Service brake excessively fluctuating (1.2.1 (e))

Offside Rear Exhaust silencer insecure (8.1.1 (b) (i))

Offside Rear Service brake excessively fluctuating (1.2.1 (e))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength floor at sill edge (5.3.6 (a) (i))

Windscreen washer not working (3.5 (a))

Offside Rear Passenger's seat insecure base (6.2.6 (a) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Lower Suspension arm pin or bush worn but not resulting in excessive movement nearside and offside (5.3.4 (a) (i))

Headlamp lens slightly defective nearside and offside (4.1.1 (b) (i))

Nearside Front inner arch cover missing

Nearside Rear Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear exhaust rear section securing clamp missing

Offside Steering rack gaiter damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

engine under tray not fully secure

under trays, outer sill covers fitted obscure some components and prescribed areas

Nearside Front Brake pipe corroded, covered in grease or other material corroded (1.1.11 (c))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement rear bush (5.3.4 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

Nearside Rear Brake pipe excessively corroded (1.1.11 (c))

Offside Front Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Offside Rear Brake pipe excessively corroded (1.1.11 (c))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Inner Brake pad(s) wearing thin (1.1.13 (a) (ii))

PARK BRAKE ANTI-SLIP MISSING

Brake pad(s) wear indicator illuminated (1.1.13 (a) (i))

Offside Front Position lamp not working (4.2.1 (a))

PARK BRAKE ANTI-SLIP MISSING

Offside Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Anti-lock braking system warning lamp indicates an ABS fault (3.4.1c)

Front Brakes imbalanced across an axle (3.7.B.5b)

Nearside rear brake binding (3.7.B.1)

Offside Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Front Inner Brake pad(s) less than 1.5 mm thick (3.5.1g)

Offside Front Inner Steering pivot point has excessive play rack end (2.2.B.1g)

Offside Front Inner Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Steering rack gaiter split (2.2.D.2d)

Offside Rear Outer Rear position lamp(s) not working (1.1.A.3b)

Offside Rear rear brake recording little or no effort (3.7.B.5a)

Parking brake lever has no reserve travel (3.1.6b)

Parking brake: efficiency below requirements (3.7.B.7)

Rear Inner Brake pad(s) less than 1.5 mm thick (3.5.1g)

rear parking (secondary) brakes imbalanced (3.7.B.6b)

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Rear brake disc worn, pitted or scored, but not seriously weakened both sides (3.5.1i)

Both front tyres are worn on outer edge

Front registration plate deteriorated but not likely to be misread (6.3.1d)

n/side door mirror cover missing

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

n/side door mirror cover missing

Nearside Front position lamp(s) not working (1.1.A.3b)

Rear registration plate deteriorated (6.3.1d)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

n/s/f tyre rounded off wearing off edges.

o/s/f tyre very outer edge bald close to exposing cord.(not at time of test)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)