2005 Kia Picanto

Nearside Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner/outer sill and inner wheel arch (5.3.6 (a) (i))

Nearside Seat belt anchorage prescribed area strength or continuity significantly reduced sill (7.1.1 (a) (i))

Offside Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Sill (5.3.6 (a) (i))

Oil leaking excessively from engine (8.4.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Suspension arm ball joint likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play close to excessive (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play close to excessive (5.3.4 (a) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Stop lamp(s) non-obligatory stop lamp not working high level (4.3.1 (a) (ii))

Tyre worn close to legal limit/worn on edge both front, worn heavily on edges (5.2.3 (e))

offside rear lamp unit loose

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill, next to rear beam mount (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Nearside Front Anti-roll bar linkage ball joint has slight play close to excessive (5.3.4 (a) (i))

Nearside Front Lower Suspension arm ball joint has slight play close to excessive (5.3.4 (a) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Stop lamp(s) non-obligatory stop lamp not working high level (4.3.1 (a) (ii))

Tyre worn close to legal limit/worn on edge both front, worn heavily on edges (5.2.3 (e))

offside rear lamp unit loose

Front crossmember corroded

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength sill (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Windscreen in an unacceptable condition (3.2 (c) (i))

Front crossmember corroded

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i))

Windscreen washer not working (3.5 (a))

Nearside Headlamp aim too high (4.1.2 (a))

Nearside Front position lamp(s) excessively deteriorated so that it is not visible from a reasonable distance (1.1.A.3d)

Nearside Rear Outer Suspension component mounting prescribed area is excessively corroded sill (2.4.A.3)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Rear Outer Suspension component mounting prescribed area is corroded but not considered excessive sill (2.4.A.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Front Brakes imbalanced across an axle (3.7.B.5b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)

Rear brake disc in such a condition that it is seriously weakened (3.5.1i)

Exhaust emissions Lambda reading after 2nd fast idle outside specified limits (7.3.D.3)

Exhaust emissions carbon monoxide content after 2nd fast idle excessive (7.3.D.3)

Exhaust emissions carbon monoxide content at idle excessive (7.3.D.4)

Exhaust emissions hydrocarbon content after 2nd fast idle excessive (7.3.D.3)

Exhaust noise is clearly in excess of that emitted by a similar vehicle fitted with a standard silencer in average condition (7.1.4)

Front Brakes imbalanced across an axle (3.7.B.5b)

Front Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Rear Brake pipe excessively corroded (3.6.B.2c)

Nearside rear brake binding (3.7.B.1)

Offside Front Brake pipe excessively corroded (3.6.B.2c)

Offside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Brake pipe excessively corroded (3.6.B.2c)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Brake pipe slightly damaged (2.2.D.2b)

both front top strut bearings noisey

nearside front disc shows signs of over heating

Parking brake: efficiency below requirements (3.7.B.7)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Brake pipe slightly damaged (2.2.D.2b)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

both front top strut bearings noisey

nearside front disc shows signs of over heating

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Exhaust has a minor leak of exhaust gases (7.1.2)

Nearside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Nearside Front front brake juddering slightly (3.7.A.2b)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Front Suspension arm ball joint dust cover deteriorated, but preventing the ingress of dirt (2.4.G.2)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Parking brake: parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

Service brake: service brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.7)

both rear tyres perished

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

nsf tyre bald inner edge

Brakes imbalanced across an axle (3.7.B.5b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Headlamp aim too low (1.8)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Registration plate lamp not working (1.1.C.1d)

Nearside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

nsf tyre bald inner edge

Nearside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Windscreen washer provides insufficient washer liquid (8.2.3)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Macpherson strut has slight movement at the upper attachment (2.5.A.1c)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Rear brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)