2005 Kia Picanto

Rear Coil spring corroded Both (5.3.1 (b) (i))

Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Headlamp aim too low (4.1.2 (a))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp aim too low (4.1.2 (a))

Nearside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Coil spring corroded front and rear both sides (5.3.1 (b) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Parking (secondary brake) grabbing slightly o/s and n/s (1.3.1 (c))

Rear Service brake requirements only just met. It would appear that the braking system requires adjustment or repair o/s and n/s (1.2.1 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside rear brake application uneven (3.7.B.2)

Parking brake: efficiency below requirements (3.7.B.7)

Brakes imbalanced across an axle (3.7.B.5b)

Rear rear brake application uneven (3.7.B.2)

Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Offside Front Macpherson strut has excessive movement at the upper attachment (2.5.A.1c)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)