2004 Mercedes-benz Clk

Offside Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Central Front Upper vehicle as small oil from oil filter housing not dangerous

Offside Front Service brake binding but not excessively (1.2.1 (f))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake hose slightly deteriorated slightly perished (1.1.12 (b) (ii))

Nearside Front Play in steering rack inner joint(s) ()

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Bushes (5.3.4 (a) (i))

Nearside Rear Inner Tyre has a cut in excess of the requirements deep enough to reach the ply or cords also has a nail and worn on the inner edge (5.2.3 (d) (i))

Offside Front Lower Suspension arm ball joint excessively worn Trailing arm (5.3.4 (a) (i))

Nearside Front Play in steering rack inner joint(s) ()

Offside Front Outer Tyre slightly damaged/cracking or perishing Perished (5.2.3 (d) (ii))

Rear Anti-roll bar linkage pin or bush worn but not resulting in excessive movement Bushes (5.3.4 (a) (i))

Offside Front Outer Tyre slightly damaged/cracking or perishing Perishing (5.2.3 (d) (ii))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Rear Stop lamp(s) all not working both (4.3.1 (a) (iii))

Offside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Drag link end ball joint has slight play (2.2.B.1f)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)