2002 Triumph Speed Triple

Drive chain slightly loose (6.1.7 (c) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Brake pedal is bent but brake can still be readily applied (1.1.2 (d))

Drive chain slightly loose (6.1.7 (c) (i))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Position lamp not working (4.2.1 (a))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a))

Rear Brake pedal is bent but brake can still be readily applied (1.1.2 (d))

Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Offside Front Shock absorber has a serious fluid leak (5.3.2 (b))

Rear Shock absorber has a serious fluid leak (5.3.2 (b))

Rear Upper Shock absorber has an excessively worn bush LINKAGE (5.3.2 (c))

Rear reflector missing (4.8.2 (a) (ii))

Registration plate does not conform to the specified requirements (0.1 (d))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Steering headbearing excessively stiff or notchy NOTCHY (2.2.2 (f) (i))

Suspension component pin or bush excessively worn LINKAGE UPPER PIN SIEZED (5.3.4 (a) (i))

Drive chain worn but not considered excessive (6.1.7 (c) (i))

ENGINE WARNING LIGHT ON

Exhaust has a minor leak of exhaust gases CRACKED CENTER HEADER PIPE (6.1.2 (a))

Exhaust noisy (8.1.1 (a))

Front Brake lever is bent but brake can still be readily applied (1.1.2 (d))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Registration plate lamp inoperative in the case of multiple lamps or light sources NOT ALL LEDS WORKING (4.7.1 (b) (i))

TYRE PRESSURES LOW

Nearside Front shock absorber has light misting of stanchion (2.3.3)

Steering movement slightly 'notchy' (2.2.1b)

Drive chain slightly loose (6.2.1d)

Exhaust noisy (7.1.2)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Tyre worn close to the legal limit (4.1.3(ii))

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Tyre worn close to the legal limit (4.1.3(ii))

Rear wheel bearings have slight free play (2.4.A.2c)

speedo and clutch cables poorly routed

Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition (7.1.2)

Registration plate with character(s) which are not the correct height (6.3.4a)

Handlebar mounting clamp loose (2.1.1a) DANGEROUS

Front Brake lever is bent but brake can still be readily applied (3.1.3c)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Tyre worn close to the legal limit (4.1.3(ii))

Rear wheel bearings have slight free play (2.4.A.2c)

speedo and clutch cables poorly routed

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i)) DANGEROUS

Drive chain slightly loose (6.2.1d)

Front Tyre worn close to the legal limit (4.1.3(ii))

Drive chain slightly loose (6.2.1d)

Front brake has minimal reserve travel.

Rear Tyre worn close to the legal limit (4.1.3(ii))

Drive chain slightly loose (6.2.1d)

Rear Tyre worn close to the legal limit (4.1.3(ii))

o/s/r position light not working

o/s/r stop light not working

Nearside Front Front position lamp does not illuminate immediately when switched on (1.1.3a)

Offside Front Front position lamp does not illuminate immediately when switched on (1.1.3a)

Drive chain slightly loose (6.2.1d)

Rear position lamp incorrect colour (1.1.2b)

Rear reflector on motorcycle missing (1.4.1)

Drive chain slightly loose (6.2.1d)