2008 BMW Z4

Exhaust slightly loose both lower clamps (6.1.2 (a))

Headlamp switch does not immediately illuminate all main beam headlamps (4.1.3 (a))

Offside Front Upper Shock absorber has a slightly worn bush seal lose (5.3.2 (c))

Rear Outer Brake pad(s) close to minimum limit worn more. possible slider (1.1.13 (a))

Front Tyre slightly damaged/cracking or perishing both sides (5.2.3 (d) (ii))

Nearside Front Outer Suspension arm ball joint has slight play (5.3.4 (a) (i))

Nearside Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Outer Suspension arm ball joint has slight play (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge inner edge (5.2.3 (e))

Rear Exhaust mounting defective mount at front of tailbox detached (6.1.2 (a))

Rear Tyre worn close to legal limit/worn on edge both sides inner edge worn (5.2.3 (e))

Front Tyre worn close to the legal limit (5.2.3 (e))

Nearside Front Shock absorber has a light misting of oil (5.3.2 (b))

Nearside Front Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Nearside & offside front, lower arm rear bushes have movement

Nearside Front Front position lamp(s) adversely affected by the operation of another lamp when hazards are switched on (1.1.A.3f)

Offside Front Front position lamp(s) adversely affected by the operation of another lamp when hazards are switch on (1.1.A.3f)

Offside Front position lamp(s) adversely affected by the operation of another lamp when hazards are switch on (1.1.A.3f)

nearside & offside lower arm rear bushes have movement

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Nearside Headlamp aim too low (1.8)

Offside Headlamp aim too low (1.8)