2003 Subaru Forester

Front Oil leaking excessively from engine (8.4.1 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength Inner sill (5.3.6 (a) (i))

Offside Rear Anti-roll bar likely to become detached (5.3.3 (a) (ii)) DANGEROUS

Front Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Play in steering rack inner joint(s) ()

Nearside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Oil leak, but not excessive Diff (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Rear Suspension component corroded but not seriously weakened (5.3.3 (b) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Inner sill covered in sealant

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive + diff (8.4.1 (a) (i))

Under trays fitted limiting underside view

Underside of vehicle slightly corroded

Under trays fitted limiting under side view

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Shock absorber has a light misting of oil (2.7.3)

Offside Rear Shock absorber has a light misting of oil (2.7.3)

Rear Exhaust has a minor leak of exhaust gases (7.1.2)

Brake pad(s) wearing thin (3.5.1g)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

rear exhaust bracket corroding front of silencer

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front position lamp(s) not working (1.1.A.3b)

Brake pad(s) wearing thin (3.5.1g)

Front Anti-roll bar rubber bush deteriorated but not resulting in excessive movement (2.4.G.2)

Front Exhaust has a minor leak of exhaust gases (7.1.2)

rear exhaust bracket corroding front of silencer

Headlamp aim too low (1.8)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

front and rear brake discs corroded

Nearside Rear Brake pad(s) wearing thin (3.5.1g)

Offside & nearside front antiroll bar end links have movement inside.

Tyres nearside front 1.6mm nearside rear 2.5mm.