2010 Peugeot Boxer

Oil leak, but not excessive (8.4.1 (a) (i))

exhaust corroded

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Oil leak, but not excessive (8.4.1 (a) (i))

exhaust corroded

Oil leak, but not excessive (8.4.1 (a) (i))

exhaust rusty

Exhaust emissions test not completed because smoke levels are significantly in excess of the specified limit values (8.2.2.2 (f))

Nearside Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Headlamp aim unable to be tested (4.1.2 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Side repeater not working (4.4.1 (a) (ii))

Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Windscreen washer provides insufficient washer liquid (3.5 (a))

Oil leak, but not excessive (8.4.1 (a) (i))

exhaust rusty

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Headlamp aim too low (1.8)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Central stop lamp not working

nearside front brake pad indicator sensor wire is adrift