2013 Peugeot 208

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Windscreen damaged but not adversely affecting driver's view (3.2 (a) (i))

Nearside Front Suspension rod ball joint has slight play link arm (5.3.4 (a) (i))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Suspension rod ball joint has slight play link arm (5.3.4 (a) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Front Suspension rod ball joint has slight play link arm (5.3.4 (a) (i))

Nearside Front Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Nearside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Suspension rod ball joint has slight play link arm (5.3.4 (a) (i))

Offside Rear Tyre has a cut but not deep enough to reach the ply or cords (5.2.3 (d) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive both drive shaft oil seal areas (8.4.1 (a) (i))

Nearside Inner Oil leak, but not excessive drive seal (8.4.1 (a) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Offside Side repeater not working (4.4.1 (a) (ii))

Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Inner Oil leak, but not excessive drive seal (8.4.1 (a) (i))

Offside Rear Exhaust mounting defective bracket detached (6.1.2 (a))

Front Brake pad(s) wearing thin (3.5.1g)