2003 Piaggio Vespa

Exhaust has a major leak of exhaust gases (6.1.2 (a))

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Front Headlamp aim too low (4.1.2 (a))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Front Wheel bearing has slight play (5.1.3 (a) (i))

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Rear Brake lever has inadequate reserve travel (3.1.3b)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Brake lining(s) close to minimum limit (3.2.A1f(i))

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Front wheel bearings are excessively tight (2.3.5b)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Rear Brake lining(s) close to minimum limit (3.2.A1f(i))

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Rear position lamp does not illuminate immediately when it is switched on (1.1.3a)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Stop lamp remains on when the brake is released (1.3.1e)

Exhaust is leaking but is not excessively noisey (7.1.1b)

Exhaust is leaking and excessively noisey (7.1.1b)

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Headlamp at least one does not illuminate on main beam (1.2.2a(ii))

starter button sticks in on position?

Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

starter button sticks in on position?