2004 Honda Civic

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Headlamp aim unable to be tested (4.1.2 (b))

Headlamp levelling device inoperative (4.1.5 (a))

Headlamp light source and lamp not compatible Aftermarket LED fitted to halogen headlamp (4.1.4 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Nearside Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Service brake fluctuating, but not excessively (1.2.1 (e))

Offside Rear Outer Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Bonnet cannot be secured in the closed position (3.1 (b) (i))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Rear Brake pipe corroded, covered in grease or other material slightly corroded (1.1.11 (c))

Offside Rear Brake pipe corroded, covered in grease or other material slightly corroded (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive transmission (8.4.1 (a) (i))

underside heavily corroded and floor pans are very weak

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Nearside Front Headlamp aim too high (4.1.2 (a))

Offside Rear Anti-roll bar linkage insecure and impairing directional stability (5.3.3 (a) (ii)) DANGEROUS

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive transmission (8.4.1 (a) (i))

underside heavily corroded and floor pans are very weak

Emissions NOx sensor obviously modified o2 sensor spacer fitted (8.2.2.1 (a))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content at idle exceeds default limits (8.2.1.2 (b))

Exhaust carbon monoxide content at idle exceeds manufacturer's specified limits (8.2.1.2 (b))

Front Engine mounting bracket damaged or deteriorated resulting in excessive movement (6.1.8 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Front Shock absorbers insecurely attached shock absorber bolt moves excessively on top mount (5.3.2 (a) (i))

Offside Headlamp aim too low (4.1.2 (a))

Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced rear crash bar has holes and is heavily corroded (6.1.1 (c) (i))

Nearside Front Anti-roll bar linkage insecure and impairing directional stability (5.3.3 (a) (ii)) DANGEROUS

Offside Front Anti-roll bar linkage insecure and impairing directional stability (5.3.3 (a) (ii)) DANGEROUS

Offside Front Lower Suspension component mounting prescribed area so inadequately repaired that control of the vehicle is likely to be adversely affected suspension turret poor welding repair (5.3.6 (a) (ii)) DANGEROUS

Front Headlamp lens slightly defective (4.1.1 (b) (i))

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Oil leak, but not excessive silicon repair around sump plug is leaking (8.4.1 (a) (i))

Oil leak, but not excessive transition (8.4.1 (a) (i))

underside heavily corroded and floor plans are very weak

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds manufacturer's specified limits (8.2.1.2 (a))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Suspension component ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Upper Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Hydraulic brake calliper leaking (1.1.16 (b) (i))

Brake pipe corroded, covered in grease or other material All (1.1.11 (c))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Inner Suspension arm pin or bush worn but not resulting in excessive movement Front bush (5.3.4 (a) (i))

Nearside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Front Upper Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement front bush (5.3.4 (a) (i))

Offside Front Track rod end ball joint has slight play (2.1.3 (b) (i))

Offside Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Vehicle structure is repaired but structural rigidity is not significantly reduced (6.1.1 (d) (i))

underside vehicle wax oiled

Nearside Front Brake pipe excessively corroded All brake pipes from union under bonnet (1.1.11 (c))

Nearside Front Brake pipe excessively corroded inner wing (1.1.11 (c))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength inner sill (5.3.6 (a) (i))

Offside Front Brake pipe excessively corroded inner wing (1.1.11 (c))

General signs of under body corrosion

Nearside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Offside Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

All direction indicators not working front and rear both sides (4.4.1 (a) (ii))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Offside Rear Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Suspension arm corroded but not seriously weakened both sides (5.3.3 (b) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced various points front and rear (6.1.1 (c) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Anti-lock braking system warning lamp indicates an ABS fault (1.6 (b))

Nearside Rear Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Offside Front Position lamp not working (4.2.1 (a))

Offside Rear Parking (secondary brake) on a single line braking system has inadequate effort at a wheel (1.3.1 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

advise very slight movement from n/s front and rear antiroll bar drop link ball joints advise to replace

Offside Front Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

Offside Rear Anti-roll bar linkage has excessive play in a ball joint (2.4.G.2)

advise inside surfaces of o/s n/s rear brake discs corroded also outside of o/s/r

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Stop lamp not working (1.2.1b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

advise new antiroll bar drop link fitted to n/s/f

Nearside Front Anti-roll bar linkage insecure (2.4.G.1)

advise exhaust heat shield insecure at catalytic convertor and rattling

advise slight corrosion o/s/r brake disc plate

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)