2004 Aprilia Mx 125

Side stand likely to touch road when riding.

Drive chain horseshoe locking device incorrectly fitted (6.1.7 (j) (i))

Exhaust system insecure (6.1.2 (a))

Headlamp not working on main beam (4.1.1 (a) (ii))

Side stand likely to touch road when riding.

Rear Brake master cylinder defective but brake still operating (1.1.10 (b) (i))

Rear Shock absorber has negligible damping effect (5.3.2 (b))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

DRIVE CHAIN RUBBING ON SIDE WALL OF TYRE

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Front FRONT BRAKE LEVER DAMAGED

Offside Front Shock absorber has a light misting of oil (5.3.2 (b))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Exhaust system insecure (6.1.2 (a))

Headlamp aim too high (4.1.2 (a))

Nearside Front Shock absorber has a serious fluid leak (5.3.2 (b))

DRIVE CHAIN RUBBING ON SIDE WALL OF TYRE

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Front FRONT BRAKE LEVER DAMAGED

Nearside Front Shock absorber has slight external damage to the casing (5.3.2 (b))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

FAULT ON IGNITION SWITCH ENABLING KEY TO BE REMOVED WITH ENGINE RUNNING

Front position lamp does not illuminate immediately when switched on (1.1.3a)

Registration plate margin less than the minimum requirement (6.3.4g)

NO NUMBER PLATE LIGHT FITTED

FAULT ON IGNITION SWITCH ENABLING KEY TO BE REMOVED WITH ENGINE RUNNING

Centre Front Front position lamp does not illuminate immediately when switched on (1.1.3a)

Centre Front Headlamp at least one does not illuminate on dipped beam (1.2.2a(i))

Centre Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

expansion bottle cap missing

Front wheel bearings have excessive free play (2.3.5b)

Rear Gradient brake test indicates a binding brake (3.3.D1c)

Front Front position lamp missing (1.1.1a)

Horn not working (1.7.3a)

Rear Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear reflector on motorcycle missing (1.4.1)

Rear Brake disc(s) slightly scored (3.2.A1l)

Rear Rear wheel bearings have slight free play (2.4.A.2c)

Drive chain slightly tight (6.2.1d)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

mileage not shown