2006 Aprilia Mojito 125

Front Suspension arm pin, bush or joint worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Tyre worn close to the legal limit (5.2.3 (e))

Steering headbearing has slight free play (2.2.2 (f) (i))

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Front Shock absorber has a slightly worn bush (5.3.2 (c))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Fuel cap ineffective seal missing (6.1.3 (b) (i))

Rear Brake lever has insufficient reserve travel (1.1.2 (a))

Rear Position lamp not working (4.2.1 (a))

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Front Brake pad(s) close to minimum limit (1.1.13 (a))

Front Nail in tyre ()

Front Shock absorber has a slightly worn bush (5.3.2 (c))

Registration plate deteriorated but not likely to be misread (0.1 (b))

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Front suspension has a slightly reduced damping effect (2.3.6c)

Rear Brake lining(s) close to minimum limit (3.2.A1f(i))

Rear Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Rear Brake lever has inadequate reserve travel (3.1.3b)

Rear reflector on motorcycle missing (1.4.1)

Steering headbearing has excessive free play UNDER LOAD (2.2.2)

Front Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Front suspension has a slightly reduced damping effect (2.3.6c)

Headlamp aim too low (1.6)

Rear Roller brake test indicates slight fluctuation of brake effort (3.3.A1d)

Horn not working (1.7.3a)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Headlamp aim too high (1.6)

Horn not working (1.7.3a)

Rear Brake lever has inadequate reserve travel (3.1.3b)

Rear reflector on motorcycle missing (1.4.1)

Steering movement excessively 'notchy' with the wheel raised (2.2.1b)

Nail in rear tyre

Front Tyre not fitted in accordance with side wall instruction/s (4.1.2e)

Fuel cap sealing washer missing (7.2.2c)

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Fuel cap sealing washer missing (7.2.2c)