2008 Yamaha YP400

Front Position lamp not working (4.2.1 (a))

Front Wheel bearing has excessive play (5.1.3 (a) (i))

Front Brake disc insecure (1.1.14 (a) (ii)) DANGEROUS

Front Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Brake fluid contaminated (1.8 (a))

Rear Brake fluid not visible (1.1.10 (d) (iii)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Brake pad(s) close to minimum limit (1.1.13 (a))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front fender broken, likely to fall off

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Rear Brake disc worn, but not excessively (1.1.14 (a) (i))

Nearside Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Offside Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Nearside Front Brake disc(s) has slight run out (3.2.A1m)

Rear Brake disc(s) slightly scored (3.2.A1l)

Offside Front Brake disc(s) is excessively distorted (3.2.A1m)

Offside Front Roller brake test indicates excessive fluctuation of brake effort (3.3.A1d)

Steering movement slightly 'notchy' (2.2.1b)

Front Brake disc(s) is excessively distorted (3.2.A1m)

Front Roller brake test indicates excessive fluctuation of brake effort (3.3.A1d)

Front Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Rear Tyre tread depth is below minimum requirements of 1.0mm (4.1.3(ii))

Throttle operating incorrectly (6.2.1f)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Rear Brake disc(s) slightly worn (3.2.A1l)

Rear Brake pad(s) close to minimum limit (3.2.A1f(i))

n/s piolt bulb not working but o/s pilot bulb is working