2011 Toyota Prius

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Shock absorbers has light misting of oil bothsides (5.3.2 (b))

Front Tyre(s) of different sizes are fitted on the same axle. (5.2.3 (b))

Offside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Offside Rear Service brake binding but not excessively (1.2.1 (f))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Shock absorbers has light misting of oil bothsides (5.3.2 (b))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Parking brake lever worn, but not excessively (1.1.6 (b) (i))

Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Nearside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Parking brake lever worn, but not excessively (1.1.6 (b) (i))

Rear Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Suspension arm pin or bush worn but not resulting in excessive movement both front (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Shock absorbers has light misting of oil (5.3.2 (b))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Headlamp insecure (4.1.1 (c))

Offside Front Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Offside Rear Shock absorbers light misting of oil or has limited damping effect (5.3.2 (b))

UNDER TRAY FITTED

under tray fitted at time of the test

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Front Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Front Front position lamp(s) not working (1.1.A.3b)

Offside Rear Tyre has a lump, caused by separation or partial failure of its structure (4.1.D.1b)

registration plate dirty (6.3.1d)

o/s/r chassis slight damage repaired.

Nearside Front Direction indicator not working (1.4.A.2c)

Offside Front Direction indicator not working (1.4.A.2c)

Offside Front Windscreen wiper does not clear the windscreen effectively (8.2.2)

o/s/r chassis slight damage repaired.

All position lamps not working (1.1.A.3b)

Front Headlamp not working on dipped beam (1.7.5a)

Registration plate lamp not working (1.1.C.1d)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components