2008 Ford Ka

Nearside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Offside Front Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Rear Lower Integral body structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Inner Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Rear Position lamp not working (4.2.1 (a) (ii))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Central Exhaust mounting defective (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Vehicle structure is corroded but structural rigidity is not significantly reduced both sides inner wheel arch (6.1.1 (c) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Rear Vehicle structure is corroded but structural rigidity is not significantly reduced both sides inner sill (6.1.1 (c) (i))

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Nearside Rear Axle swivel pins and bushes swivel pin and/or bush excessively worn (5.1.2 (b) (i))

Nearside Rear Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Front Coil spring fractured or broken (5.3.1 (b) (i))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Rear Axle swivel pins and bushes swivel pin and/or bush excessively worn (5.1.2 (b) (i))

Nearside Rear Inner Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Brake fluid warning lamp illuminated (1.1.10 (f))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps nearside and offside (4.7.1 (b) (ii))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Front brake disc worn, pitted or scored, but not seriously weakened (3.5.1i)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Brake hydraulic reservoir fluid close to minimum level (3.6.G.1b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nail in offside rear tyre

Oil leak

Front Brake lining(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Registration plate lamp not illuminating the registration plate (1.1.C.1e)

Nail in offside rear tyre

Oil leak