2008 Toyota Prius

Nearside Damage

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Damage

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Headlamp has a product on the light source but not seriously reducing light output both. (4.1.4 (b))

Rear Child Seat fitted not allowing full inspection of adult belt ()

Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Front Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt both. (5.3.4 (b) (ii))

Front Headlamp has a product on the light source but not seriously reducing light output both. (4.1.4 (b))

Rear Child Seat fitted not allowing full inspection of adult belt ()

Rear Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Red warning light is on

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Nearside Rear Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Offside Front Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Offside Rear Tyre tread pattern not visible over the whole tread area when minimum depth required is 1.0mm (5.2.3 (e)) DANGEROUS

Red warning light is on

Covers fitted makes unable to check some testable items

Exhaust mounting defective (6.1.2 (a))

Front Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Offside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Rear Brake disc significantly and obviously worn Both rear (1.1.14 (a) (i))

Rear Brake pad(s) less than 1.5 mm thick Both Reaar (1.1.13 (a) (ii)) DANGEROUS

Covers fitted makes unable to check some testable items

Exhaust mounting defective (6.1.2 (a))

Front Suspension component mounting prescribed area is corroded but not considered excessive both sides (5.3.6 (a) (i))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Anti-roll bar linkage ball joint dust cover severely deteriorated Both Front (5.3.4 (b) (i))

Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Exhaust mounting defective (6.1.2 (a))

Suspension component mounting prescribed area is corroded but not considered excessive ALL (5.3.6 (a) (i))

Tyre slightly damaged/cracking or perishing ALL (5.2.3 (d) (ii))

Vehicle has covers fitted unable to see certain testable items

Anti-roll bar linkage ball joint dust cover severely deteriorated Both Front (5.3.4 (b) (i))

Axle swivel pins and bushes swivel pin and/or bush slightly worn (5.1.2 (b) (i))

Exhaust mounting defective (6.1.2 (a))

Nearside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Front Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Suspension component mounting prescribed area is corroded but not considered excessive ALL (5.3.6 (a) (i))

Tyre slightly damaged/cracking or perishing ALL (5.2.3 (d) (ii))

Vehicle has covers fitted unable to see certain testable items

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Front Anti-roll bar likely to become detached both (5.3.3 (a) (ii)) DANGEROUS

Front Tyre tread depth below requirements of 1.6mm both (5.2.3 (e)) DANGEROUS

Nearside Rear Stop lamp(s) not working (4.3.1 (a) (ii))

Nearside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Front Anti-roll bar linkage ball joint dust cover damaged, but preventing the ingress of dirt (2.4.G.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Nearside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Offside Windscreen wiper does not clear the windscreen effectively (8.2.2)

Windscreen washer provides insufficient washer liquid (8.2.3)

Offside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Rear Tyre worn close to the legal limit (4.1.E.1)

Rear Brake pad(s) wearing thin (3.5.1g)

Offside Rear Registration plate lamp not working (1.1.C.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

both f/ wipper blade slightly worn

Front registration plate deteriorated but not likely to be misread (6.3.1d)

Nearside Front Tyre worn close to the legal limit (4.1.E.1)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Front position lamp(s) not working (1.1.A.3b)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

o/s/rear/tyre/perishing

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)