2009 Honda Cbf 125 M-9

Drive chain slightly loose (6.1.7 (c) (i))

Rear Suspension arm corroded but not seriously weakened swing arm (5.3.3 (b) (i))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Front Brake effort inadequate at a wheel (1.2.1 (a) (i))

Offside Front Stop lamp not working (4.3.1 (a) (ii))

Roller brake test The less effective brake control does not achieve an efficiency of 25% (1.2.2 (a) (i))

Front Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Rear Wheel hub worn to the extent that wheel security is adversely affected (5.2.1 (b) (ii)) DANGEROUS

Front Indicator switch faulty (4.4.2 (a) (i))

Front Mudguard insecure ()

Nearside Front Mirror insecure

Offside Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

Offside Front FENDER INSECURE

Rear Drive chain slightly loose (6.1.7 (c) (i))

Drive chain excessively loose (6.1.7 (c) (i))

Front Brake fluid reservoir fluid level significantly below minimum level (1.1.10 (d) (ii))

Front Position lamp missing (4.2.1 (a))

Rear Suspension arm pin or bush excessively worn Swingarm bushes (5.3.4 (a) (i))

Rear reflector defective or damaged by more than 50% of the reflecting surface Obscured (4.8.1 (a) (ii))

Stop lamp not working (4.3.1 (a) (ii))

Front Brake pad(s) less than 1.0 mm thick (1.1.13 (a)) DANGEROUS

Rear Tyre tread depth is below minimum requirements of 1.0mm (5.2.3 (e)) DANGEROUS

Front Brake lever is short but brake can still be readily applied ball end broken off (1.1.2 (d))

Front Tyre worn close to the legal limit 1.3mm (5.2.3 (e))

Offside Front Brake fluid below minimum mark (1.1.10 (d) (i))

Offside Front Brake lever is short but brake can still be readily applied (1.1.2 (d))

chain rusty

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Horn not working (1.7.3a)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Brake lever is short but brake can still be readily applied (3.1.3c)