2002 Mercedes-benz Vito

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Nail in tyre ()

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

both sill corroded inner and outer have been patched surface corrosion all over both inner and outer sills

Exhaust has a major leak of exhaust gases both centre sections have holes (6.1.2 (a))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Nail in tyre ()

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Offside Front Coil spring corroded (5.3.1 (b) (i))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

both sill corroded inner and outer have been patched surface corrosion all over both inner and outer sills

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Offside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced Inner sill - x2 (6.1.1 (c) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced Inner & outer sills (6.1.1 (c) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Front Windscreen wiper does not clear the windscreen effectively split (3.4 (b) (ii))

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Integral body structure is corroded but structural rigidity is not significantly reduced Inner sill - x2 (6.1.1 (c) (i))

Offside Front Integral body structure is corroded but structural rigidity is not significantly reduced Inner & outer sills (6.1.1 (c) (i))

Parking brake efficiency only just met. It would appear that the braking system requires adjustment or repair. (1.4.2 (a) (i))

Offside Front Play in steering rack inner joint(s) ()

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Headlamp aim too high (4.1.2 (a))

Offside Front Play in steering rack inner joint(s) ()

Nearside Rear Shock absorbers has light misting of oil (5.3.2 (b))

Nearside Front Seat belt anchorage prescribed area strength or continuity significantly reduced outer sill (7.1.1 (a) (i))

Nearside Headlamp aim too high (4.1.2 (a))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Headlamp aim too high (4.1.2 (a))

Offside Parking brake inoperative on one side (1.4.1 (a))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Rear Brake pipe excessively corroded (1.1.11 (c))

Nearside Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Nearside Side repeater slightly discoloured (4.4.3 (a))

Offside Side repeater slightly discoloured (4.4.3 (a))

Rear Brake pipe slightly corroded (3.6.B.2c)

Front Windscreen has a sticker or other obstruction encroaching by more than 10mm within zone 'A' (8.3.1b)

FUEL SMELL ENGINE BAY

Front Exhaust has a minor leak of exhaust gases (7.1.2)