2007 Ford Focus C-max

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Exhaust Lambda reading after 2nd fast idle outside specified limits (8.2.1.2 (c))

Exhaust carbon monoxide content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Exhaust emits excessive dense blue smoke during acceleration (8.2.1.2 (g))

Exhaust hydrocarbon content after 2nd fast idle exceeds default limits (8.2.1.2 (b))

Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Nearside Front Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Front Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Headlamp lens seriously defective (4.1.1 (b) (ii))

Offside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Offside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Brake fluid close to minimum mark (1.1.10 (d) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Outer Integral body structure is deformed but structural rigidity is not significantly reduced sill (6.1.1 (a) (i))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Rear Registration plate does not conform to the specified requirements (0.1 (d))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Offside Front Outer Integral body structure is deformed but structural rigidity is not significantly reduced sill (6.1.1 (a) (i))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Wing mirror cover missing

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Upper Anti-roll bar ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Offside Front Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Nearside Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Rear Coil spring corroded (5.3.1 (b) (i))

Nearside Rear Service brake binding but not excessively (1.2.1 (f))

Nearside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Wing mirror cover missing

Offside Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Rear Coil spring corroded (5.3.1 (b) (i))

Offside Rear Inner Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Rear Suspension arm corroded but not seriously weakened (5.3.3 (b) (i))

Rear Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Rear Registration plate deteriorated but not likely to be misread (0.1 (b))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Brake disc significantly and obviously worn X2 (1.1.14 (a) (i))

Front Undertray insecure (8.1.1 (b) (i))

Fuel cap/sealing device ineffective (6.1.3 (b) (i))

Nearside Rear Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (5.2.3 (d) (i))

Offside Front Anti-roll bar linkage ball joint dust cover no longer prevents the ingress of dirt (5.3.4 (b) (ii))

Front Brake pad(s) wearing thin (1.1.13 (a) (ii))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Electronic parking brake warning indicates a malfunction (1.1.6 (e))

Engine MIL inoperative or indicates a malfunction (8.2.1.2 (h))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Front Side repeater not working (4.4.1 (a) (ii))

Offside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Side repeater not working (4.4.1 (a) (ii))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Front Registration plate deteriorated but not likely to be misread (0.1 (b))

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement Rear bush (5.3.4 (a) (i))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Nearside Rear Inner Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Offside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Headlamp not working on dipped beam (4.1.1 (a) (ii))

Offside Headlamp has a product on the lens so that the light output is severely reduced (4.1.4 (b))

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Windscreen washer provides insufficient washer liquid (8.2.3)

Nearside Rear Tyre has ply or cords exposed (4.1.D.1b)

Offside Headlamp not working on dipped beam (1.7.5a)

Offside Registration plate lamp not working (1.1.C.1d)

Rear Brake pad(s) wearing thin (3.5.1g)

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components

Vehicle's internal headlight adjuster altered to recheck lights