2010 Mercedes-benz C

Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Rear Parking brake inoperative on one side (1.4.1 (a))

Nearside Rear Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Nearside Rear Upper Suspension arm pin or bush excessively worn (5.3.4 (a) (i))

Offside Front Side repeater not working (4.4.1 (a) (ii))

Service brake efficiency below requirements (1.2.2 (a) (i))

Nearside Front Suspension arm pin or bush likely to become detached (5.3.4 (a) (ii)) DANGEROUS

Nearside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Offside Rear Brake pipe leaking on a hydraulic braking system (1.1.11 (b) (ii)) DANGEROUS

Offside Rear Service brake has no recorded effort at a wheel (1.2.1 (a) (ii)) DANGEROUS

Central Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Front Inner Tyre worn close to legal limit/worn on edge both sides (5.2.3 (e))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material both sides (1.1.11 (c))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Rear Sub-frame corroded but not seriously weakened (5.3.3 (b) (i))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Rear Service brake excessively binding (1.2.1 (f))

Front Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Nearside Front Anti-roll bar linkage ball joint dust cover severely deteriorated (5.3.4 (b) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Lower Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Brake pipe corroded, covered in grease or other material Both front under wheel arch area (1.1.11 (c))

Nearside Side repeater not working (4.4.1 (a) (ii))

Brake pipe corroded, covered in grease or other material Both front under wheel arch area (1.1.11 (c))

Nearside Rear Tyre worn close to the legal limit 1.88ml (4.1.E.1)

Offside Front Upper Brake pipe slightly corroded (3.6.B.2c)

Offside Rear Tyre worn close to the legal limit (4.1.E.1)

emission test wont register

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Windscreen has damage to an area less than a 40mm circle outside zone 'A' (8.3.1d)

Engine covers fitted obscuring some components in the engine bay

Under-trays fitted obscuring some underside components