2012 Ford Mondeo

Rear Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Anti-roll bar ball joint has slight play both rears (5.3.4 (a) (i))

Nearside Rear Tyre slightly damaged small cuts (5.2.3 (d) (ii))

Brake cable damaged (1.1.15 (a))

Offside Rear Brake lever has restricted free movement (1.1.15 (e))

Front Suspension component mounting prescribed area is corroded to the extent that control of the vehicle is likely to be adversely affected front x member hold (5.3.6 (a) (ii)) DANGEROUS

Nearside Front Tyre tread depth below requirements of 1.6mm (5.2.3 (e)) DANGEROUS

Parking brake efficiency less than 50% of the required value (1.4.2 (a) (ii)) DANGEROUS

Nearside Rear Tyre slightly damaged small cuts (5.2.3 (d) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Rear rear exhaust heat shield loos

Nearside Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Headlamp aim too high (4.1.2 (a))

Offside Front Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Rear Brake pad(s) less than 1.5 mm thick (1.1.13 (a) (ii)) DANGEROUS

Nearside Front Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Offside Front Steering rack has excessive free play detected at the steering wheel (steering rack fitted) (2.3 (a) (i))

Front Tyre tread depth below requirements of 1.6mm both front (5.2.3 (e)) DANGEROUS

Rear Brake pad(s) wearing thin (1.1.13 (a) (ii))

Offside Front diesel heater damaged

Offside Rear Lower Coil spring corroded (5.3.1 (b) (i))

Offside Track rod end ball joint has slight play (2.1.3 (b) (i))

Nearside Front tyre worn inner edge

Nearside Rear Nail in tyre ()

Offside Front tyre worn inner edge

Nearside Front position lamp(s) not working (1.1.A.3b)

Offside Front position lamp(s) not working (1.1.A.3b)

Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

rear brake application slightly uneven