2008 Nissan Navara

Central Front Oil leak, but not excessive (8.4.1 (a) (i))

Central Rear Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Central Front Oil leak, but not excessive (8.4.1 (a) (i))

Central Rear Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Offside Front All position lamps light intensity significantly reduced (4.2.3 (a) (ii))

Offside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Front Lower Shock absorbers has a slightly worn bush both (5.3.2 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Power steering close to minimum mark (2.1.5 (b) (i))

Prop shaft joint worn, but not excessively front propshaft rear joint (6.1.7 (c) (i))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both foremost leaf spring mounting areas on chassis (5.3.6 (a) (i))

Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Tyre slightly damaged/cracking or perishing both nearside outer sidewalls (5.2.3 (d) (ii))

Upper Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Front passenger door cannot be opened from inside the vehicle (6.2.3 (a))

Front Anti-roll bar linkage ball joint has slight play both (5.3.4 (a) (i))

Front Lower Shock absorbers has a slightly worn bush both (5.3.2 (c))

Offside Front Brake pipe corroded, covered in grease or other material (1.1.11 (c))

Power steering close to minimum mark (2.1.5 (b) (i))

Prop shaft joint worn, but not excessively front propshaft rear joint (6.1.7 (c) (i))

Rear Brake pipe corroded, covered in grease or other material both (1.1.11 (c))

Rear Suspension component mounting prescribed area is corroded but not considered excessive both foremost leaf spring mounting areas on chassis (5.3.6 (a) (i))

Rear Vehicle structure or chassis corroded within 30cm of a mounting, but not seriously affecting overall security (6.2.2 (d) (i))

Tyre slightly damaged/cracking or perishing both nearside outer sidewalls (5.2.3 (d) (ii))

Upper Stop lamp(s) non-obligatory stop lamp not working (4.3.1 (a) (ii))

Front Exhaust has a minor leak of exhaust gases flexi (6.1.2 (a))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Front Exhaust has a minor leak of exhaust gases flexi (6.1.2 (a))

Front Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Nearside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Windscreen washer provides insufficient washer liquid (3.5 (a))

Oil leak, but not excessive engine (8.4.1 (a) (i))

Offside Front Track rod end ball joint has excessive play (2.1.3 (b) (i))

Offside Windscreen washer provides insufficient washer liquid (3.5 (a))

Nearside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Nearside Front Wheel bearing has excessive play (5.1.3 (a) (i))

Offside Front Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

engine cover fitted

Offside Track rod end ball joint has excessive play (2.2.B.1f)

Supplementary Restraint System warning lamp indicates a fault air bag light on (5.4.2)

engine cover fitted

Battery insecure (1.9.1)

Nearside Headlamp aim too high (1.8)

Nearside rear child seat fitted not allowing full inspection of seat belt.

Offside Headlamp aim too high (1.8)

Nearside rear child seat fitted not allowing full inspection of seat belt.

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)