2003 Yamaha R6

Position lamp not working low beam (4.2.1 (a))

Rear Brake fluid significantly below minimum mark (1.1.10 (d) (ii))

Rear reflector missing (4.8.2 (a) (ii))

Throttle operating incorrectly not returning (6.2.7 (a) (i))

Engine mounting/bracket missing upper engine bolts missing (6.1.8 (a) (ii)) DANGEROUS

Front Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) DANGEROUS

Drive chain slightly tight (6.1.7 (k) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

Front Wheel bearing has slight play (5.1.3 (a) (i))

upper engine mounting bolt missing

Exhaust noise is clearly in excess of that emitted by a similar motorcycle fitted with a standard silencer in average condition (8.1.1 (a))

Front Brake indicates excessive fluctuation of brake effort (1.2.1 (e))

Headlamp aim too high (4.1.2 (a))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition (7.1.2)

Front Floor brake test indicates a binding brake (3.3.C2c)

Rear reflector on motorcycle missing (1.4.1)

Steering headbearing has excessive free play (2.2.2)

Exhaust noise is clearly in excess of that emitted by a similar motor bicycle fitted with a standard silencer in average condition (7.1.2)

Front Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear Floor brake test indicates a binding brake (3.3.C2c)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Rear reflector on motorcycle missing (1.4.1)

Front Brake component worn but not seriously reduced in strength (3.2.A1)

Front shock absorber has light misting of stanchion (2.3.3)