2011 Ford Ranger

Nearside Front Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive Outrigger, inner sill (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area is corroded but not considered excessive Outrigger, inner sill (7.1.1 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Towbar component corroded, but not excessively Cross beam (6.1.6 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Exhaust emissions exceed manufacturer's specified limit .65 (8.2.2.2 (a))

Nearside Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Inner Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Rear fog lamp missing (4.5.1 (a) (ii))

Nearside Front Upper Shock absorbers has a slightly worn bush (5.3.2 (c))

Nearside Seat belt anchorage prescribed area is corroded but not considered excessive Outrigger, inner sill (7.1.1 (a) (i))

Offside Seat belt anchorage prescribed area is corroded but not considered excessive Outrigger, inner sill (7.1.1 (a) (i))

Rear Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (1.2.1 (b) (i))

Towbar component corroded, but not excessively Cross beam (6.1.6 (a))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

Rear Wheel bearing has slight play Both Sides (5.1.3 (a) (i))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Stop lamp(s) lens defective which has no effect on emitted light lens cracked (4.3.1 (b) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear reflector defective or damaged by up to 50% of the reflecting surface covered by tape (4.8.1 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security mounting point (6.2.2 (d) (i))

Offside Front Outer Drive shaft flexible coupling slightly deteriorated (6.1.7 (d) (i))

Offside Rear Stop lamp(s) lens defective which has no effect on emitted light lens cracked (4.3.1 (b) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear reflector defective or damaged by up to 50% of the reflecting surface covered by tape (4.8.1 (a) (i))

Oil leak, but not excessive transmission oil leak (8.4.1 (a) (i))

nsr and osr cab bed corroded

osr and nsr tow bar/bumper ends corroded

rear tail gate badly corroded

Exhaust emissions exceed default limit of 1.5m-1 (8.2.2.2 (b))

Nearside Front Service brake excessively binding (1.2.1 (f))

Nearside Headlamp aim projected beam image is obviously incorrect (4.1.2 (c))

Nearside Registration plate lamp likely to become detached body corroded (4.7.1 (c) (ii))

Offside Rear Brake cable insecure (1.1.15 (c))

Battery insecure but not likely to fall from carrier (4.13 (a) (i))

Nearside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Nearside Rear Stop lamp(s) lens defective which has no effect on emitted light lens cracked (4.3.1 (b) (i))

Nearside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Nearside Rear reflector defective or damaged by up to 50% of the reflecting surface covered by tape (4.8.1 (a) (i))

Offside Front Anti-roll bar linkage pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Cab or chassis corroded within 30cm of a mounting, but not seriously affecting overall security mounting point (6.2.2 (d) (i))

Offside Front Outer Drive shaft flexible coupling slightly deteriorated (6.1.7 (d) (i))

Offside Rear Stop lamp(s) lens defective which has no effect on emitted light lens cracked (4.3.1 (b) (i))

Offside Rear Wheel bearing has slight play (5.1.3 (a) (i))

Offside Rear reflector defective or damaged by up to 50% of the reflecting surface covered by tape (4.8.1 (a) (i))

Oil leak, but not excessive transmission oil leak (8.4.1 (a) (i))

nsr and osr cab bed corroded

osr and nsr tow bar/bumper ends corroded

rear tail gate badly corroded

Offside Rear Direction indicator insecure (4.4.1 (c) (i))

Offside Rear Position lamp insecure (4.2.1 (c) (i))

Offside Stop lamp(s) insecure (4.3.1 (c) (i))

Rear fog lamp insecure (4.5.1 (c) (i))

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Exhaust emissions exceed default limit of 1.5m-1 (8.2.2.2 (b))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Rear Direction indicator insecure (4.4.1 (c) (i))

Offside Rear Position lamp insecure (4.2.1 (c) (i))

Offside Stop lamp(s) insecure (4.3.1 (c) (i))

Rear fog lamp insecure (4.5.1 (c) (i))

Exhaust emissions exceed manufacturer's specified limit (8.2.2.2 (a))

Nearside Front Headlamp aim too low (4.1.2 (a))

Nearside Front Outer Drive shaft joint constant velocity boot split or insecure, no longer prevents the ingress of dirt (6.1.7 (g) (ii))

Nearside Front Shock absorbers has a serious fluid leak (5.3.2 (b))

Nearside Front Shock absorbers insecurely attached (5.3.2 (a) (i))

Nearside Rear Direction indicator lens defective which has no effect on emitted light (4.4.1 (b) (i))

Offside Front Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Vehicle structure is corroded but structural rigidity is not significantly reduced (6.1.1 (c) (i))

suspension component corroded slightly

Offside Front Outer Seat belt anchorage prescribed area is corroded but not considered excessive SILL (7.1.1 (a) (i))

Offside Rear Position lamp not working (4.2.1 (a) (ii))

Offside Front Outer Seat belt anchorage prescribed area is corroded but not considered excessive SILL (7.1.1 (a) (i))

Nearside Front Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt clip lose (2.5.C.1a)

Offside Front Inner Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Offside Front Outer Front constant velocity joint gaiter deteriorated, but preventing the ingress of dirt (2.5.C.1a)

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Nearside Front Track rod end socket spring weak split pin missing (2.2.B.1e)

Offside Front Front constant velocity joint gaiter damaged to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Front Track rod end damaged and unserviceable (2.2.C.1d)

Nearside Rear Rear wheel bearing has slight play (2.6.2)

Nearside Registration plate lamp not working (1.1.C.1d)

Offside Registration plate lamp not working (1.1.C.1d)