2005 Nissan Terrano

Front Brake disc significantly and obviously worn (1.1.14 (a) (i))

Nearside Front Inner Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Nearside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Nearside Rear Integral body structure corroded to the extent that the rigidity of the assembly is significantly reduced inner arch (6.1.1 (c) (i))

Nearside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Offside Front Inner Track rod end ball joint dust cover excessively damaged or deteriorated so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Offside Front Suspension component mounting prescribed area excessively corroded significantly reducing structural strength multiple locations (5.3.6 (a) (i))

Offside Rear Suspension spring mounting prescribed area excessively corroded significantly reducing structural strength (5.3.6 (a) (i))

Offside Rear Vehicle structure or chassis has excessive corrosion, seriously affecting its strength within 30cm of a body mounting (6.2.2 (d) (i))

Parking brake efficiency below requirements (1.4.2 (a) (i))

Nearside Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Nearside Front Exhaust has a minor leak of exhaust gases (6.1.2 (a))

Nearside Front Hydraulic brake calliper corroded but not seriously weakened (1.1.16 (d) (i))

Nearside Front Outer Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Bumper mountings corroded but not likely to become detached (6.1.4 (a) (i))

Offside Front Hydraulic brake calliper corroded but not seriously weakened (1.1.16 (d) (i))

Offside Front Outer Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Offside Front Service brake binding but not excessively (1.2.1 (f))

Offside Front Steering box has seepage (2.1.1 (e) (i))

Offside Front Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

oil light displayed on dash

tow bar and brackets corroded

Brake hose has slight corrosion to ferrule both fronts (1.1.12 (f) (i))

Manufactures engine and body covers fitted restricting full inspection

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Rear body mounting corroded and broken away from body but not effecting overall body security

Offside Brake master cylinder/servo mounting prescribed area is corroded but not considered excessive A pillar (1.1.21 (e) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Seat belt webbing slightly damaged or frayed (7.1.2 (b) (ii))

Supplementary restraint system warning lamp does not illuminate (7.1.6 (a))

Suspension arm corroded but not seriously weakened all front and rear (5.3.3 (b) (i))

Underside coated in wax oil restricting full inspection of body suspension and brake pipes

all body mounts corroded

fuel tank slightly damp

Manufactures engine and body covers fitted restricting full inspection

Nearside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Nearside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Front Brake hose has slight corrosion to ferrule (1.1.12 (f) (i))

Offside Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Offside Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Front Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Nearside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Offside Front Suspension arm pin or bush worn but not resulting in excessive movement (5.3.4 (a) (i))

Rear Suspension component mounting prescribed area is corroded but not considered excessive (5.3.6 (a) (i))

Windscreen washer jets misaligned and not providing sufficient fluid to the windscreen (3.5 (a))

Front Brake pad(s) wearing thin (3.5.1g)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

All standard equipment guards fitted at time of test not allowing full inspection

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Offside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Offside Rear Anti-roll bar linkage has slight play in a ball joint (2.4.G.2)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Towbar component slightly corroded (6.6.1)

Nearside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

Offside Rear Suspension component mounting prescribed area is excessively corroded anti roll bar link mounting (2.4.A.3)

Offside Rear Suspension spring mounting prescribed area is excessively corroded (2.4.A.3)

All standard equipment guards fitted at time of test not allowing full inspection

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Offside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Towbar component slightly corroded (6.6.1)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front wheel bearing has slight play (2.5.A.3c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

Fuel pipe leaking (7.2.3)

Nearside Front Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Offside Front wheel bearing has slight play (2.5.A.3c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Nearside Rear Anti-roll bar linkage ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.4.G.2)

Nearside Rear Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Front constant velocity joint gaiter deteriorated to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Track rod end ball joint has slight play (2.2.B.1f)

Offside Front wheel bearing has slight play (2.5.A.3c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Supplementary Restraint System warning lamp indicates a fault (5.4.2)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front wheel bearing has slight play (2.5.A.3c)

Nearside Track rod end ball joint has slight play (2.2.B.1f)

Offside Front wheel bearing has slight play (2.5.A.3c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Offside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Prop-shaft universal joint worn

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Nearside Headlamp aim too low (1.8)

Offside Front Anti-roll bar linkage has excessive play in a pin/bush (2.4.G.2)

Offside Headlamp aim too low (1.8)

Offside Rear position lamp(s) not working (1.1.A.3b)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Offside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Prop-shaft universal joint worn

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Offside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Exhaust has a major leak of exhaust gases (7.1.2)

Exhaust has part of the system excessively deteriorated (7.1.1a)

Brakes imbalanced requirements only just met. It would appear that the braking system requires adjustment or repair. (3.7.B.5b)

Front Brake pipe slightly corroded (3.6.B.2c)

Front Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)

Nearside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Offside Front suspension has slight movement at a wishbone pin or bush (2.5.A.1c)

Rear Brake pipe slightly corroded (3.6.B.2c)

Rear Suspension component mounting prescribed area is corroded but not considered excessive (2.4.A.3)