2010 Toyota Auris

Front Oil leak, but not excessive (8.4.1 (a) (i))

Front Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Position lamp not working (4.2.1 (a) (ii))

Offside Rear Tyre tread depth below requirements of 1.6mm (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Front Undertray insecure (8.1.1 (b) (i))

Nearside Front Headlamp not working on main beam (4.1.1 (a) (ii))

Offside Front Position lamp not working (4.2.1 (a) (ii))

Offside Front Track rod end ball joint dust cover insecure so that it no longer prevents the ingress of dirt (2.1.3 (g) (ii))

Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Rear Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Nearside Front Track rod end ball joint dust cover damaged or deteriorated, but preventing the ingress of dirt (2.1.3 (g) (i))

Oil leak, but not excessive (8.4.1 (a) (i))

Rear Brake disc in such a condition that it is seriously weakened (1.1.14 (a) (ii)) DANGEROUS

Headlamp aim too low (4.1.2 (a))

Rear Registration plate lamp does not illuminate simultaneously with the position lamps (4.7.2 (a))

Windscreen wiper does not clear the windscreen effectively all (3.4 (b) (ii))

Front Suspension arm pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Offside Front Headlamp aim too low (4.1.2 (a))

Offside Rear Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Front Suspension arm pin or bush worn but not resulting in excessive movement Both (5.3.4 (a) (i))

Nearside Rear Tyre slightly damaged/cracking or perishing (5.2.3 (d) (ii))

Nearside Front Outer Tyre has a cut in excess of the requirements deep enough to reach the ply or cords (4.1.D.1a)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Rear Nail in tyre x 2 ()

Nearside Side repeater not working mirror unit (1.4.A.2c)

Nearside Rear Nail in tyre ()

Offside Front Tyre has a bulge, caused by separation or partial failure of its structure (4.1.D.1b)