2012 Alfa Romeo Mito

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Offside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Rear Exhaust deteriorated

Nearside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Front Anti-roll bar linkage ball joint excessively worn (5.3.4 (a) (i))

Offside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Nearside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Nearside Rear Registration plate lamp inoperative in the case of multiple lamps or light sources (4.7.1 (b) (i))

Offside Front Macpherson strut corroded but not seriously weakened (5.3.3 (b) (i))

Rear Exhaust deteriorated

undertray fitted

Nearside Front Coil spring fractured or broken (5.3.1 (b) (i))

Nearside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

undertray fitted

Nearside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Offside Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

exhaust rear silencer in poor condition

both rear tyres uneven wear slightly

rear exhaust silencer outer casing corroded not leaking gases

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

both rear tyres uneven wear slightly

rear exhaust silencer outer casing corroded not leaking gases

Nearside Rear Shock absorbers has a serious fluid leak (5.3.2 (b))

Front Brake disc worn, pitted or scored, but not seriously weakened Both lipped (1.1.14 (a) (ii))

Rear Both tyres wearing on inner edge slightly

Rear Exhaust box deteriorated

Nearside Front wheel has slight buckles on inner rim.

exhaust tailbox very rotten.

n/s/f tyre bald inner edge

n/s/r tyre tread uneven wear

o/s/f tyre bald inner edge

o/s/r tyre tread uneven wear

Nearside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Tyre tread depth below requirements of 1.6mm (4.1.E.1)