2012 Peugeot 508

Exhaust emits excessive smoke or vapour but not likely to obscure the vision of other road users (8.2.2.2 (c))

Exhaust heat shield slightly loose

Engine MIL inoperative or indicates a malfunction (8.2.2.2 (g))

Offside Front Outer Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (ii)) DANGEROUS

Exhaust emits excessive smoke or vapour but not likely to obscure the vision of other road users (8.2.2.2 (c))

Exhaust heat shield slightly loose

Front Tyre worn close to legal limit/worn on edge Both sides (5.2.3 (e))

Rear Anti-roll bar pin or bush worn but not resulting in excessive movement anti roll bar d bushes, both sides worn (5.3.4 (a) (i))

Rear Anti-roll bar linkage ball joint has slight play both nearside and offside (5.3.4 (a) (i))

Offside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Offside Rear Tyre tread depth below requirements of 1.6mm 1mm (5.2.3 (e)) DANGEROUS

Front Brake disc worn, pitted or scored, but not seriously weakened (1.1.14 (a) (ii))

Nearside Rear Tyre worn close to legal limit/worn on edge Worn to legal limit. 1.6mm (5.2.3 (e))

Offside Outer Drive shaft joint constant velocity boot severely deteriorated (6.1.7 (g) (i))

Nearside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Rear Rear wheel bearing has excessive play (2.6.2)

Nearside Rear Rear wheel bearing rough when rotated (2.6.1)

Offside Front Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Brake pad(s) less than 1.5 mm thick (3.5.1g)

Nearside Front Brake pad(s) wearing thin (3.5.1g)

Offside Front Brake pad(s) wearing thin (3.5.1g)

Nearside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Offside Front Front wheel bearing rough when rotated (2.5.A.2)

Offside Front Outer Front constant velocity joint gaiter insecure to the extent that it no longer prevents the ingress of dirt etc (2.5.C.1a)

Offside Rear Tyre tread depth below requirements of 1.6mm (4.1.E.1)

Parking brake: efficiency below requirements (3.7.B.7)