2006 Nissan Micra

poor image on nearside headlamp.......

Nearside Rear Position lamp adversely affected by the operation of another lamp (4.2.3 (c))

Nearside Suspension arm ball joint excessively worn (5.3.4 (a) (i))

Registration plate lamp inoperative in the case of a single lamp or all lamps (4.7.1 (b) (ii))

Offside Front Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

poor image on nearside headlamp.......

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Tyre has a tear, caused by separation or partial failure of its structure (5.2.3 (d) (i))

Nearside Headlamp aim so that beam "kick up" is not visible on the screen (4.1.2 (a))

Nearside Rear Tyre has a bulge, caused by separation or partial failure of its structure (5.2.3 (d) (i))

Nearside Rear Wheel bearing rough when rotated (5.1.3 (b) (i))

Offside Windscreen wiper does not clear the windscreen effectively (3.4 (b) (ii))

Offside Rear Tyre worn close to legal limit/worn on edge (5.2.3 (e))

Oil leak, but not excessive (8.4.1 (a) (i))

Nearside Front Brake pipe slightly corroded (3.6.B.2c)

Offside Front tyre is worn on the outer edge............

exhaust rear heat shield is loose........

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Nearside Headlamp not working on dipped beam (1.7.5a)

Offside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Front position lamp(s) not working (1.1.A.3b)

Nearside rear parking brake recording little or no effort (3.7.B.6a)

Offside Front position lamp(s) not working (1.1.A.3b)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Offside Lower Ball joint has excessive play (2.2.B.1f)

Offside rear parking brake recording little or no effort (3.7.B.6a)

Parking brake: efficiency below requirements (3.7.B.7)

Offside Headlamp aim beam image obviously incorrect (1.8.A.1b)

Nearside Front Tyre has ply or cords exposed (4.1.D.1b)

Offside Front Brake pad(s) less than 1.5 mm thick (3.5.1g)

bonnet release catch is in need of adjustment