2002 Suzuki GZ125

Drive chain slightly loose (6.1.7 (c) (i))

Rear Brake lining(s) close to minimum limit (1.1.13 (a))

Rear Tyre worn close to the legal limit (5.2.3 (e))

Rear Brake excessively binding (1.2.1 (f))

Front Wheel bearing play so excessive it is likely to break up (5.1.3 (a) (ii)) DANGEROUS

Drive chain slightly tight (6.1.7 (k) (i))

Drive chain excessively tight (6.2.1d)

Drive chain worn to excess (6.2.1e)

Front Drive chain sprocket worn to excess (6.2.1e)

Offside Front shock absorber seal failed and leaking oil (2.3.3)

Rear Drive chain sprocket worn to excess (6.2.1e)

Rear Floor brake test indicates a sticking brake (3.3.C2c)

Throttle has a significant change in engine speed whilst moving the steering from lock to lock (2.1.4)

Throttle operating incorrectly (6.2.1f)

Front Brake pad(s) close to minimum limit (3.2.A1f(i))

Offside Front Front shock absorber seal failed and leaking oil (2.3.3)

Rear shock absorber has inadequate damping effect. (2.4.A.3b)

Drivers seat not fitted correctly

Front Tyre worn close to the legal limit (4.1.3(ii))

Front Floor brake test indicates a sticking brake (3.3.C2c) DANGEROUS

Front Roller brake test indicates a sticking brake (3.3.A1a) DANGEROUS

Locking device(s) not correctly fitted which may make the motor bicycle dangerous to ride (6.2.1h) DANGEROUS

Rear Tyre has a tear caused by separation or partial failure of its structure (4.1.2a(ii)) DANGEROUS

Front Tyre worn close to the legal limit (4.1.3(ii))

Brake pedal has inadequate reserve travel (3.1.3b)

rear brake cable starting to sieze up

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))

Rear Brake locking device missing (3.2.A1e)

Rear Stop lamp does not illuminate immediately a brake applies (1.3.1a)

Steering movement excessively 'notchy' with the wheel raised (2.2.1b)

Steering movement excessively stiff with the weight on the lower bearing (2.2.1a)

Brake lever cannot be applied smoothly (3.1.3d)

Throttle has a significant change in engine speed whilst moving the steering from lock to lock (2.1.4)

Front Brake pad(s) less than 1.5 mm thick (3.2.A1f(i))